Kenmore 790.7755 manual Setting Oven Controls, Setting the Clock, Press Display

Setting Oven Controls

•Setting the Clock

•Changing between 12or24 hourdisplay

•Silent Control Operation

Setting the Clock

The CLOCK _-Q_ pad is used to set the clock. The clock may be

set for 12 or 24 hour time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is

first plugged in, or when the power supply to the range has been interrupted, the clock in the display will flash (See Fig. 1).

Fig. 1

INSTRUCTIONS PRESS DISPLAY

To set the clock (example below for 1:30):

1. Press (f_").		"CLO" will appear		in the display	(See Fig. 2).	G
,	Press		pads	to set the time	of day to 1:30
	(See Fig. 3). Press _.		"CLO" will disappear		and the clock
	will start (See Fig. 4).

Changing between 12 or 24 hour time of day display:

1. Press and hold _ for 6 seconds untill "12h" or"24h"

(_for 6 seconds

appears in the display.

Fig. 2

Fg3

Fig. 4

2.	Press	_C_aX, to switch		between the	12 and 24 hour time of day		@
	display.		"12h" or "24h" will be displayed			(See Figs. 5 or 6).
3.	Press	(_	to accept	the desired	change	or press @ to	Fig. 5
	reject	the change.

4.Reset the correct time as described in To set the clock above. Please note that if the 24 hour time of day mode was chosen,

the clock will now display time from 00:00 through 23:59 hours. Fig. 6

Setting Silent Control Operation

The DELAY START (,._a_y)and FLEX CLEAN (,.C_a_ pads control the Silent Control operation feature. The Silent Control

v

operation feature allows the oven control to be operated without sounds or beeps whenever necessary. If desired the control can be programmed for silent operation and later returned to operating with all the normal sounds and beeps.

INSTRUCTIONS PRESS DISPLAY

To change control from normal sound to silent control operation:

1.To tell if your range is set for normal or silent operation press

	and hold d_	_ for 6 seconds.	(See Fig. 7)	for 6 seconds	Fig. 7
2.	Press _	to switch between	normal sound operation and	@

silent operation mode. The display will show either "SP" (See Fig. 8) or" ==" (See Figs. 8 or 9).

Fig. 8

If "SP" appears (See Fig. 8), the control will operate with normal sounds and beeps. If "= =" appears (See Fig. 9), the control is set for silent operation mode.

, Press to accept the change or press @ to reject the °rO Fig. 9

change. 15