Kenmore 790.7865, 790.7965, 790.7866 Setting Warmer Drawer Controls contd, To Remove Warmer Drawer

Setting Warmer Drawer Controls (cont'd)

Warmer Drawer Recommended

Food Settings Table

Food item	Setting
Bacon	HI
Hamburger Patties	HI
Poultry	HI
Pork Chops	HI
Fried Foods	HI
Pizza	HI
Gravies	MED
Casseroles	MED
Eggs	MED
Roasts (Beef, Pork, Lamb)	MED
Vegetables	MED
Biscuits	MED
Rolls, hard	MED
Pastries	MED
Rolls (soft)	LO
Empty Dinner Plates	LO

To Set the Warmer (Warm & Ready TM) Drawer Thermostat Control (some models)

The thermostat control is used to select the temperature of the warmer drawer. It is located on the control panel (See Fig. 3 on previous page). To set the thermostat, push in and turn the knob to the desired setting. The temperatures are approximate, and are designated by HI, MED and LO.

1.Turn the knob to select the desired temperature setting.

2.For best results, preheat the drawer before adding food. An empty drawer will preheat in approximately 15 minutes.

3.Turn the thermostat control to OFF after use.

Warmer (Warm & Ready TM) Drawer Temperature Selection

(some models)

Refer to the table in the side column for recommended settings. If a particular food is not listed, start with the medium setting. If more crispness is desired, remove the lid or aluminum foil.

Most foods can be kept at serving temperatures by using the medium setting.

When a combination of foods are to be kept warm (for instance, a meat with 2 vegetables and rolls), use the high setting.

Refrain from opening the warmer drawer while in use to eliminate loss of heat from the drawer.

Warmer (Warm & Ready TM) Drawer Indicator Light (some models)

The indicator light is located above the Warmer Drawer thermostat control. It turns on when the control is set, and stays on until the control is turned OFF. The warmer drawer is inoperable during the Self-Clean cycle. The indicator light will not come on during the Self-Clean cycle.

To Remove and Replace Warmer (Warm & Ready TM) Drawer (some models)

Pull up with finger

Left Glide

Push down with finger

Fig. 1

To Remove Warmer Drawer:

1. _ Turn power off before removing the warmer drawer.

2.Open the drawer to the fully opened position.

3.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Fig. 1).

5.Pull the drawer away from the range.

To Replace Warmer (Warm & Ready TM) Drawer:

1.Pull the bearing glides to the front of the chassis glide (See Fig. 2).

2.Align the glide on each side of the drawer with the glide slots on the range.

3.Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3. This will minimize possible damage to the bearing glides.

NOTE: The Warmer Drawer will NOT operate while in the Self-Clean and '!Oven Lockout" modes

Electrical Shock Hazard can occur and result in

serious injury or death. Disconnect appliance from electric power before cleaning and servicing the warmer drawer.

Bearing Glide

Fig. 2

16