Kenmore 790.9603, 790.9600, 790.9601, 790.9602 manual General Care & Cleaning, How to Clean

Models: 790.9602 790.9603 790.9601 790.9600

1 24
Download 24 pages 32.17 Kb
Page 18
Image 18
General Care & Cleaning

General Care & Cleaning

Cleaning Table

Surfaces

How to Clean

Aluminum (Trim Pieces) & VinylUse hot, soapy water and a cloth. Dry with a clean cloth.

Painted and Plastic Control Knobs,

For genera/ cleaning, use hot, soapywater and a cloth. Formoredifficultsoilsand

Body Parts, and Decorative Trim

built-up grease, apply a liquid detergent directly onto the soil. Leave on soil for 30

 

to 60 minutes. Rinse with a damp cloth and dry. DO NOT use abrasive cleaners

 

on any of these materials; they can scratch. To remove control knobs, turn to the

 

OFF position; grasp firmly and pull straight off the shaft. To replace knobs after

 

cleaning, line up the flat sides of both the knob and the shaft; then push the knob

 

into place.

Stainless Steel, Chrome Control Panel, Decorative Trim

Porcelain Enamel Broiler Pan and Insert, Door Liner, Body Parts, Warmer Drawer (some models)

Oven Racks

Oven door

Before cleaning the controlpanel, turn all controls to OFF and remove the control knobs. To remove, pull each knob straight off the shaft. Clean using hot, soapy water and a dishcloth. Rinse with a clean water using a dishcloth. Be sure to squeeze excess water from the cloth before wiping the panel; especially when wiping around the controls. Excess water in or around the controls may cause damage to the appliance.To replace knobs after cleaning, line up the flat sides of both the knob and the shaft; then push the knob into place.

Clean stainless steel with hot, soapy water and a dishcloth. Rinse with clean water and a cloth. Do not use cleaners with high concentrations of chlorides or chlorines. Do not use harsh scrubbing cleaners. Only use kitchen cleaners that are especially made for cleaning stainless steel. Always be sure to rinse the

cleaners from the surface as bluish stains may occur during heating that cannot be removed.

Gentle scouring with a soapy scouring pad will remove most spots. Rinse with a 1:1 solution of clear water and ammonia. Ifnecessary, cover difficult spots with an ammonia-soaked paper towel for 30 to 40 minutes. Rinse with clean water and a damp cloth, and then scrub with a soap-filled scouring pad. Rinse and wipe drywith a clean cloth. Remove all cleaners orthe porcelain may become damaged during future heating. DO NOT use spray oven cleaners on the cooktop.

Remove oven racks. Ifthey are not removed during the Self-Clean cycle their color will turn slightly blue and the finish will be dull. See "Removing and Replacing Oven Racks" under Before Betting Oven Controls.

Use a mild, abrasive cleaner, following manufacturer's instructions. Rinse with clean water and dry. After cleaning the racks, rub the sides of the racks with wax paper or a cloth containing a small amount of salad oil (this will make the racks glide easier into the oven rack positions).

Use soap & water to thoroughly clean the top, sides and front of the oven door. Rinse well. You may use a glass cleaner on the outside glass of the oven door. DO NOT immerse the door in water. DO NOT spray or allow water or the glass cleaner to enter the door vents. DO NOT use oven cleaners, cleaning powders or any harsh abrasive cleaning materials on the outside of the oven door.

DO NOT clean the oven door gasket. The oven door gasket is made of a woven material, on Self-Cleaning models, which is essential fora good seal. Care should be taken not to rub, damage or remove this gasket.

Ceramic Cooktop

See Cooktop Cleaning and Maintenance in the General Care & Cleaning

 

section.

18

Page 18
Image 18
Kenmore 790.9603, 790.9600, 790.9601, 790.9602 manual General Care & Cleaning, How to Clean