Setting

Warmer

Drawer Controls

 

 

 

 

 

 

Arranging Warmer Drawer (Warm & Ready TM

 

 

 

 

 

 

Drawer) Rack Positions

(some models)

WARMER

DRAWER

Warmer

(Warm

&

 

 

Note: Use the warmer

drawer

to keep hot foods hot such as:

 

 

Ready

TM)

Drawer

vegetables,

gravies,

meats,

casseroles, biscuits and rolls,

 

 

indicator

 

Light

 

pastries and heated dinner plates.

 

 

The indicator light is located

The rack can be used in 2 ways:

 

 

 

 

above the Warmer Drawer

• In the upright position to allow low profile food items to

 

 

thermostat

control

(some

be placed both under and on top of the rack (for

 

 

 

 

models). It turns on when

example, rolls or biscuits on top of the rack and a

 

 

 

 

the control is set, and stays

casserole dish under - See Fig. 1).

 

 

 

 

on until the control

is turned

In the downward

position

to allow you to place light

 

 

OFF. The warmer drawer is

weight food items and empty dishware (for example,

 

 

inoperable during the Self-

 

 

 

 

 

 

rolls or pastries and dinner plates - See Fig. 2).

Clean cycle. The indicator

 

 

light will not come on during

 

the Self-Clean cycle.

Fig. 2

NOTE: The warmer drawer is equipped with a catch which may require extra force when opening and closing the drawer.

To Operate the Warmer (Warm & Ready TM)

Drawer

Always start with hot food. It is not recommended to heat cold food in the warmer drawer.

All food placed in the warmer drawer should be covered with a lid or aluminum foil to maintain quality. Do not use plastic wrap to cover food. Plastic may melt onto the drawer and be very difficult to clean.

Use only dishes, utensils and cookware recommended for oven use in the warmer drawer.

Always use pot holders or oven mitts when removing food from the warmer drawer as cookware and plates will be HOT.

To Set the Warmer (Warm & Ready TM) Drawer Thermostat Control (some models)

The thermostat control is used to select the temperature of the warmer drawer. It is located on the control panel (See Fig. 3 on previous page). To set the thermostat, push in and turn the knob to the desired setting. The temperatures are approximate, and are designated by HI, MED and LO.

1.Turn the knob to select the desired temperature setting.

2.For best results, preheat the drawer before adding food. An empty drawer will preheat in approximately 15 minutes.

3.Turn the thermostat control to OFF after use.

NOTE: Thewarmer drawerwill NOT 0peratewhile inthe Self-Clean and "Oven Lockout" modes

Warmer (Warm & Ready TM) Drawer Temperature Selection (some models)

Refer to the table in the side column for recommended settings. If a particular food is not listed, start with the medium setting. If more crispness is desired, remove the lid or aluminum foil.

Most foods can be kept at serving temperatures by using the medium setting.

When a combination of foods are to be kept warm (for instance, a meat with 2 vegetables and rolls), use the high setting.

Refrain from opening the warmer drawer while in use to eliminate loss of heat from the drawer.

Warmer Drawer Recommended Food Settings Table

Food Item

 

 

Setting

Hamburger

patties, poultry

& porks chops

HI

Pizza, fried foods & bacon

 

HI

Gravies, roasts (beef, pork & lamb)

MED

Vegetables

& eggs

 

MED

Pastries, biscuits & hard rolls

MED

Rolls (soft) & empty dinner

plates

LO

To Remove & Replace Warmer (Warm & Ready TM) Drawer (some models)

occur and result in serious injury or death.

_'__i Disconnect applianceElectricalfrom electricShock powerHazardbeforecan

cleaning and servicing the warmer drawer.

16

Page 16
Image 16
Kenmore 790.9634 manual Setting Warmer Drawer Controls