Kenmore 790.9659 Lo %, Setting, Surface, Controls, Right, Front, Operating, _Mddle, @ +Mddle, Fig

Setting	Surface	Controls	O
• Operating the Triple Surface Radiant Control			e,	+ Mid d Ie
Operating	the TRIPLE	Surface Element	....
The cooktop is equipped with a TRIPLE radiant surface element
located at the right front cooktop position (See Fig. 1). Indicator			Fig. 1	Fig. 2
lights on the control panel at that position are used to indicate
what portions of the Triple radiant element will heat. The iNNER
light indicates that only the		inner element will heat. The		All
+MIDDLE light indicates that both inner and middle elements

will heat together. The ALL light indicates that all 3 portions of	_Mddle
the element will heat. You may switch between all of these
different settings at any time during cooking.

To Operate the Triple Surface Element:

Fig. 3

1.Place correctly sized cookware on the radiant surface element.

2.Touch and hold the O pad for the Triple element position until a beep is

v

heard. The display will show" - - ".

NOTE: Each time a pad is touched a beep will sound. If no further pads are touched within 10 seconds the request to power the element ON will clear.

3.Select the iNNER (See Fig. 2), +MIDDLE (See Fig. 3) or ALL 3 elements

Element ._ ....

(See Fig. 4) to heat by pressing the k,,size_jJpau u.,,_, twice or three times (See Figs. 4 & 5 show indicator lights with ALL 3 elements selected).

_{_iiiiiiiiiiiiiiiiiiiiii_i_'i'_@,

Fig. 4

4.TouchtheTripleebment@padoncetoturnONthepowerleveIHior

pad once for Lo (See Fig. 4). The Hot Surface indicator light will turn ON when the element becomes hot.

{}

@ +Mddle

Lo %/

5.	Each touch of the _		or _-A')	pad will decrease	or increase the power
			v
	level by 1/2 from 9.0 through 3.0. Simmer power levels between 3.0 and 1.0
	will decrease or increase by .2 increments. Lo is the lowest power level
	available. Note: The power level may be adjusted at any time while the
	element is ON.
6.	When cooking	has been completed		touch the O	pad once to turn the	Right
	element OFF.
	Each surface element provides a constant amount of heat at each setting. A					Front
	glowing red surface heating area extending beyond the bottom edge of the					Hot Surface
	cookware indicates the cookware is too small for the surface heating area.
	Note: The Hot Surface		indicator light will remain ON if the cooktop is still			Fig. 5
	hot and will remain ON until the heating surface area has cooled sufficiently.					r_
	Note: If no element size is choosen when the Triple element is turned ON,
	the control will	default to the inner coil only. See page			11, Fig. 1 for
	recommended	surface cooking settings.

Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.

Do not place aluminum foil or plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements.

12