![](/images/new-backgrounds/1093330/9333075x1.webp)
Before You Call • Solutions to common problems
Before you call for service, review the are provided with the problem listed:
Problem
Poor baking results.
Appliance is not level.
following list. It may save you time & expense. Possible solutions to these problems
Solution
•Many factors affect baking results. Make sure the proper oven rack position is used. Center food in the oven and space pans to allow air to circulate. Allow the oven to preheat to the set temperature before placing food in the oven. Try adjusting the recipe's recommended temperature or baking time. If you feel the oven is too hot or cool, see Adjusting oven temperature in Setting Oven Controls section.
•Be sure floor is level, strong & stable enough to adequately support range.
•If floor is sagging or sloping, contact a carpenter to correct the situation.
•Poor installation. Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at base of appliance until the rack is level.
•Kitchen cabinet alignment may make range appear not level. Be sure cabinets are square & have sufficient room for appliance clearance.
Cannot move appliance easily. Appliance must be accessible for service.
•Cabinets not square or are built in too tightly. Contact builder or installer to make appliance accessible.
•Carpet interferes with appliance. Provide sufficient space so appliance can be lifted over carpet.
• Gas | line is | Have a flexible CSA International approved |
metal | appliance connector | installed. |
Oven portion of appliance does not | • | Be sure | regulator | gas valve is turned | to | ON. See | installation | instructions. | |||
operate. | • | The time of day | is not | set. The | time | of | day must | first | be set | in order to | |
|
| ||||||||||
|
| operate | the oven. See | Setting | clock | in | Setting Oven | Controls | section. |
•Be sure the oven controls are set properly for the desired function. See Setting Oven Controls section and review instructions for the desired cooking function in this manual or see "Entire appliance does not operate" in this checklist.
Entire appliance does not operate. | • | Make | sure power cord is plugged | properly into outlet. |
|
| • Electrical power outage. Check house lights to be sure. Call your local | ||||
|
| electric company for service outage information. |
| ||
| • | Service | wiring is not complete. Call | for assistance (See | |
|
| back cover}. |
|
|
Oven control beeps and displays F code error,
•Oven control has detected a fault or error condition. Press sToP key pad to clear the error code. Try Bake or Broil function. If the F code error repeats, remove power from appliance, wait 5 minutes and then repower appliance and set clock with the correct time of day. Try Bake or Broil function again.
If the fault recurs, press STOPto clear and call
38