=FLUSH OUT THE TUBING
Turn the main water supply on
and flush out the tubing until the water is clear.
Shut the water off at the water _ _'_),_ valve after about one quart of
water has been flushed through the tubing•
9.CONNECT THE TUBING TO THE REFRIGERATOR
NOTES:
Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into the wall outlet.
•If your refrigerator does not have a water filter,
we recommend installing one. If your water supply has sand or particles that could clog the screen of the refrigerator's water valve, install the filter in the water line near the refrigerator.
•Do not use old hoses; only use new hoses provided by the manufacturer. For more information call
•Remove the plastic flexible cap from the refrigerator connection.
•Place the compression nut and ferrule (sleeve) onto the end of the tubing. (See figure 1)
•Insert the end of the tubing into the connection as far as possible• While holding the tubing, tighten the fitting•
CAUTION: Check to make sure that leaks are not occurring in the water line.
Back of refrigerator
W' (6.35 mm) Tubing
Tubing
1/4"(6,35 mm) Compression Nut
Ferrule
| Refrigerator |
Figure 1 | Connection |
|
Fasten the tubing into the tubing clamp attached to the back of the refrigerator.
First, loosen the screw fastening the clamp. Next, insert the tubing in the groove• Finally,
10. PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall.
11.START THE ICEiVIAKER
Set the icemaker power switch to the ON (I) position, The icemaker will not begin to operate until it reaches its operating temperature of 15°F
or below. It will then begin operation automatically if the icemaker power switch is in the ON (I) position,
14
