Kenmore 795.5103 manual Water Filter

WATER FILTER

•Filter Reset: When the Filter Reset icon turns on, you

have to change the water filter. Press the Filter Reset button c,,_T_, for 3 seconds to turn the icon off.

HOL_3S_C

Before removing or installing water filter:

1.IMPORTANT: Turn off household water supply.

2.Take out the top shelf and move it to the lowest level,

(\2/)

/

/

Removing the water filter:

1.For first-time installation, remove filter substitute cap (_) by turning it counterclockwise and pulling it down. The substitute cap must be retained for the future. If the filter is removed and not replaced, it is necessary to reinstall the substitute cap to prevent water leaks from the filter housing.

S

!

2.For filter replacement, remove old filter by turning it counterclockwise and pulling it down.

Installing the water filter

1.Remove the red cap from the filter.

2.Hold the filter with the unlock symbol _ facing towards you as shown in the figure below. Insert the filter into the filter receptacle on the right side of the refrigerator compartment.

,\ ,/

/ • •/

3.Push the water filter up into the filter receptacle and rotate it clockwise to lock it into place. Once installed correctly, the lock symbol i_ should be facing you and you should not be able to rotate the filter clockwise any more,

NOTE: After installation, if you notice that the lock symbol is not facing you or you can continue to rotate

the filter clockwise; remove the filter and repeat installation to prevent water leaks.

After installing water filter:

1.Replace the shelf to the initial position.

2.After installing filter, turn on household water supply.

3.Dispense 2.5 gallons (9.46 liters) of water to purge the system, depressing and releasing the dispenser pad in cycles of 30 seconds ON and 60 seconds OFF. Open the refrigerator door and check the shelf area for water leaks.

To purchase replacement water filters, call 1-800-4-MY-HOME ®.

23