Cycle time too short
Excessive Weight Hazard
Use two or more people to move and install dryer. Failure to do so can result in back or other injury.
•Is the Auto Dry Cycle ending early?
The load may not be contacting the sensor strips. Level the dryer.
Change the dryness level setting on Auto Dry Cycles. Increasing or decreasing the dryness level will change the amount of drying time in a cycle.
Do not use a dryer rack with an Auto Dry Cycle.
Lint on load
•Is the lint screen clogged?
Clean lint screen. Check for air movement.
Stains on load or drum
•Was dryer fabric softener properly used?
Add dryer fabric softener sheets at the beginning of the cycle. Fabric softener sheets added to a partially dried load can stain your garments.
Drum stains are caused by dyes in clothing (usually blue jeans). This will not transfer to other clothing.
Loads are wrinkled
•Was the load removed from dryer at the end of the cycle? Select Touch Up Cycle to tumble the load with water and heat to help smooth out wrinkles from a load left in the dryer.
Was the dryer overloaded?
Dry smaller loads that can tumble freely. Smaller loads yield best results with the Refresh Cycle. Results may also vary depending on fabric type. This cycle is best for reducing wrinkles and odors from loads consisting of
Loads are still wrinkled following SteamCare cycles? Make sure water is connected to the dryer. Check that water inlet hose is connected to both the faucet and dryer'swater inlet valve. Check that the water supply is turned on. These cycles are best for smoothing out wrinkles and reducing odors from loads consisting of
NOTE: Refer to garment care label instructions, Dry clean only garments are not recommended.
Odors
Have you recently been painting, staining or varnishing in the area where your dryer is located?
If so, ventilate the area. When the odors or fumes are gone from the area, rewash and dry the clothing.
•Is the dryer being used for the first time?
The new electric heating element may have an odor. The odor will be gone after the first cycle.
Is water connected to the dryer?
Check that water inlet hose is connected to both the faucet
and dryer's water inlet valve. Check that the water supply is turned on.
To remove odors left in garments after wearing, select the Refresh cycle for small loads of two to four garments. This cycle is best for reducing wrinkles and odors from loads consisting of
29
