Kenmore Washer owner manual Connect the Inlet Hoses, For standpipe or laundry tub drain systems

4, Open clamp. Twist hose back and forth while pushing down onto drain connector at the bottom of the wash- er, Continue until hose contacts the

ribbed stop on the cabinet.

Y

•For floor drain installation, see kit num- ber required under "Alternate Parts You May Need."

5, Place clamp over area marked "CLAMR" Release clamp.

1/4"

Connect the Inlet Hoses

1, Insert new flat washers (supplied) into each end of the inlet hoses. Firmly seat the washers in the couplings.

1.Drain Hose

2.Clamp

3.Ribbed Stop

4.Cabinet

For standpipe or laundry tub drain systems:

1, Open yellow, single-wire clamp with pliers and slide over hooked end of drain hose to secure the rubber and

corrugated sections together.

1.Hooked end

2.Drain hose

2, Put hooked end of drain hose into

laundry tub or standpipe. Rotate hook to eliminate kinks.

To prevent drain water from going back into the washer:

•Do not straighten hooked end of drain hose. Do not force excess drain hose

into standpipe, Hose should be secure, but loose enough to provide a gap of air.

•Do not lay excess drain hose in bot- tom of laundry tub.

12

1.Coupling

2.Washer

Connect the inlet hoses to the water faucets

Make sure the washer basket is empty.

2.Attach the hose with the red coupling to the hot water faucet. Screw on cou-

pling by hand until seated on the washer.

3, Attach the hose with the blue coupling to the cold water faucet. Screw on

coupling by hand until seated on the washer.

4, Using pliers, tighten the couplings with an additional two-thirds turn.

NOTE: Do not overtighten. Damage to the valves can result.

11