Kenmore Washer owner manual Solution, WontDrain

Most laundering problems are easily solved if you understand the cause. Check these lists for common laundry and washer problems. If you need further assistance, see the back cover,

Problem Possible Cause

Washer Leaks Household plumbing isIeaking.

Inlet hoses not tight.

Inlet hose washers not properly seated,

Drain hose not propedy clamped or is off.

Drain is cIogged.

Tub moved forward during unloading, causing water to deflect off tub dng.

Unit not level causing water to deflect off tub ring.

Load is unbalanced. Spray rinses are deflecting off load.

Washer is overloaded. Fills or

Solution

Repair pIumbing.

Tighten hoses (see "lnstailation Instructions").

Reseat washers (see "Installation Instructions").

Clamp drain hose (see "Installation Instructions").

Remove drain clogs. Sink, standpipe, or floor drain must be able to handle

17 gal (64 L) of water per minute.

Ensure tub is centered before starting washer.

Ensure front feet are installed and nuts are tightened. Level washer. Reset rear legs (see "Instaliation Instructions").

Redistribute the load.

Reduce Ioad size.

spray rinses are deflecting off load.

Won'tDrain/	Drain hose is kinked or	Straighten or unplug hose (see
Won'tSpin/	clogged.	"Installation Instructions").
Wet Loads	Correct operation of	After a wash or rinse, the washer will
	neutral drain,	drain without spinning. After draining,
		the spinning begins.
	Lid is open.	Close the lid.
	Drain hose is more than	Lower drain hose (see "InstalIation
	96 in (2.4 m) above floor.	Requirements").
	Too much detergent -	Use less detergent.
	excessive sudsing.
	Wrong cycle for load	Choose a cycle with a higher spin
	being washed,	speed (see "Operating Your
		Washer"),

25