Kenmore Washer owner manual Problem Possible Cause Machine, Stops

Problem	Possible Cause
Machine	Power cord not plugged in.
Stops	No power at plug.
	Fuse blown or circuit
	breaker open.
	Using an extension cord.
	Timer is not Iined up.
	Timer knob not pulled out.
	Machine is overloaded.
Agitator Not	The top of the agitator moves
Working	only in one direction.
	The top of the agitator is loose.
Water Level	The top of the agitator is much
Too Low/Not	higher than the highest water
Completely	Ievel. This creates a perception
Filling	of the washer not being full,
Tub is	Tub pulled forward when
Crooked	unloading,
	Tub moves.
	Unit not level.

Lint on Load	Improper sorting.
	Overloading.
	Paper or tissue in pockets.
	Not enough detergent.

Solution

Plug into a grounded 3 prong outlet.

Check electrical source or call electrician.

Replace fuse or reset circuit breaker. If problem continues, call electrician.

Do not use extension cords.

Turn timer to the right slightly and pull to start.

Set and pull out knob.

Wash smaller loads.

This is normal.

This is normal.

This is normal.

Ensure tub is centered before starting washer.

This is normal.

Ensure front feet are installed and nuts are tightened. Level washer. Reset rear legs (see "Installation Instructions").

Sort lint givers from lint takers and by color.

Lint can be trapped in load if overloaded. Wash smaller loads.

Clean out pockets before washing,

Use enough detergent to hold lint in water.

Detergent not dissolving. Water temperatures lower than 70°F (21°C).

Use wash water warmer than 70°F (21°C).

27