Installation for Camera Unit
Installation for Camera Unit
1 Clean the surface to which the rear view camera is to be installed. Use a cloth or other item to wipe oil, wax, dust and any other dirt from installation surface.
2CAUTION
•Locate the rear view camera in the position you want it installed. Adjust the angle of the rear view camera, and install so that the camera doesn’t touch the car.
•When sticking to a glass surface, stick it on in a position that assures the camera doesn’t touch the rear window.
Install on the center part
Glass surface
2 Peel off the sheet on back of the camera bracket (Accessory3) and stick it on.
2CAUTION
•Press the camera bracket with your fingers to stick it to installation surface. Touching the adhesive surface or sticking the unit on a second time reduces adhesive strength, which may result in the unit falling.
•If the temperature of the attachment surface is low, warm with a hair dryer or other means before installing to improve adhesive strength.
3 Attach the rear view camera to the camera bracket (Accessory3) with the installation screws (Accessory4).
2CAUTION
•The rear view camera is attached so that the logo of Kenwood is on the upper surface.
4 Adjust the angle so that bumper or rear edge of the car is displayed at the bottom of the monitor screen.
Camera bracket (Accessory3)
Camera bracket (Accessory3)
Screw (Accessory4)
96°
130°
Monitor screen
Bumper or rear edge of car
English 5