10 Adjust the camera angle so that the rear part of the vehicle or the rear bumper is visible at the bottom of the monitor screen.

Vehicle rear part or bumper

When adjusting the camera angle, be careful not to stretch the camera cord.

11 After adjusting the camera angle, tighten the retaining screws firmly.

Inspect the retaining screws at times. If they are loose, tighten them firmly.

12 Perform the operations in “Camera Setting” (page 8). (CMOS-300 only)

If an adjustment is not possible in the currently available range, change the camera position before retrying.

13 Fix the camera firmly in position.

Peel off the paper liner from the double-side adhesive tape on the camera bracket and attach it. After attaching, push the camera bracket with your finger to ensure close adhesion.

Do not touch the adhesive surface with your hand or peel and reattach an attached tape, as these will degrade the adhesive force and may cause the camera bracket to be detached. If required, secure the bracket on the vehicle body using the camera bracket clamping screw.

Camera bracket clamping screw

Installing the Power Supply Box

1Attach double-side adhesive tape on the power supply box and then attach it under the carpet on the front passenger seat side.

Do not attach the power supply box in the following place.

-Place moistened by water.

-Unstable surface.

-Place that comes in the way of driving.

-Under high temperature.

Installing the Switch Unit (CMOS-300 only)

1Clean the switch unit installation surface.

Using a commercially available cleaner, wipe dirt, moisture and oil away from the surface on which the switch unit is to be attached.

2Attach double-side adhesive tape on the bottom of the switch unit and then attach it in an easy-to-operate position, for example near the dashboard on the driver seat side.

English 5