Initial Settings

Adjusting initial settings

Initial settings lets you perform initial set up of
different settings for this unit.
1FUNCTION display
Shows the function status.
1 Press SOURCE and hold until the unit turns
off.
2 Press OPEN to open the front panel.
3 Press FUNCTION and hold until CLOCK
appears in the display.
4 Press FUNCTION to select one of the initial
settings.
Press FUNCTION repeatedly to switch between
the following settings:
CLOCK—WARN—D OPEN—AUX—DIM—
BRIGHT—SW—TEL—DISP
Use the following instructions to operate each
particular setting.
• To cancel initial settings, press BAND.
• You can also cancel initial settings by holding
down FUNCTION until the unit turns off.

Setting the time

This is used to set the time on the unit’s clock
display.
1 Press OPEN to open the front panel.
2 Press FUNCTION to select CLOCK.
Press FUNCTION until the time appears in the
display.
3 Select the portion of the time display you
wish to set with 2/3.
Pressing 2/3will select a portion of the clock
display:
HOUR—MINUTE
As you select portions of the clock display the
portion selected will blink.
4 Select the correct time with 5/∞.
Pressing 5will increase the selected hour or
minute. Pressing ∞will decrease the selected
hour or minute.
1
En
44
08
Section