Kenwood Accessories/InstallationP rocedure, Accessories, Installation Procedure

Accessories/InstallationP rocedure

Accessories

1	6 *1
..........1	..........2
2	7 *2
..........1 (2m: 6.5 ft)	..........2

38 *2

..........6.......... 1

49 *3

..........6		..........1 (3m: 9.8 ft)
5	*1	DDX470/DDX4070BT/
		DDX370/DDX3070
		only.
	*2	DDX790/DDX770/
		DDX7070BT only.
..........1	*3	DDX790/DDX770/
		DDX7070BT/ DDX470/

DDX4070BT only.

Installation Procedure

1To prevent a short circuit, remove the key from the ignition and disconnect the ·

battery.

2Make the proper input and output wire connections for each unit.

3Connect the speaker wires of the wiring harness.

4Connect the wiring harness wires in the following order: ground, battery, ignition.

5Connect the wiring harness connector to the unit.

6Install the unit in your car.

7 Reconnect the · battery.

8 Press the reset button.

9 Perform the Initial Setup.

WARNING

•If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box.

•Do not cut out the fuse from the ignition wire (red) and the battery wire (yellow). The power supply must be connected to the wires via the fuse.

¤

•Mounting and wiring this product requires skills and experience. For best safety, leave the mounting and wiring work to professionals.

•Make sure to ground the unit to a negative 12V DC power supply.

•Do not install the unit in a spot exposed to direct sunlight or excessive heat or humidity. Also avoid places with too much dust or the possibility of water splashing.

•Do not use your own screws. Use only the screws provided. If you use the wrong screws, you could damage the unit.

•If the power is not turned ON (“Miswiring DC Offset Error”, “Warning DC Offset Error” is displayed), the speaker wire may have a short- circuit or touched the chassis of the vehicle and the protection function may have been activated. Therefore, the speaker wire should be checked.

•If your car’s ignition does not have an ACC position, connect the ignition wires to a power source that can be turned on and off with the ignition key. If you connect the ignition wire to a power source with a constant voltage supply, such as with battery wires, the battery may be drained.

•Only for DDX790/DDX770/DDX7070BT: If the console has a lid, make sure to install the unit so that the faceplate will not hit the lid when closing and opening.

English 79