•If the fuse blows, first make sure the wires are not touching to cause a short circuit, then replace the old fuse with one with the same rating.
•Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals.
•Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the · wires or ground them to any metal part in the car.
•When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not use one from each). For example, if you connect the ª connector of the left speaker to a front output terminal, do not connect the · connector to a rear output terminal.
•After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are working properly.
•Mount the unit so that the mounting angle is 30° or less.
•Do not press hard on the panel surface when installing the unit to the vehicle. Otherwise scars, damage, or failure may result.
•This unit has the cooling fan to decrease the internal temperature. Do not mount the unit in a place where the cooling fan of the unit is blocked. Blocking these openings will prevent the cooling of the internal temperature and result in malfunction.
Cooling fan
DDX790/DDX770/DDX7070BTonly
1Before installation, remove the screws.
⁄Do not use the removed screws for installation.
2Detach the sleeve using the two extraction keys 7 then slide off the
mounting sleeve.
Accessory 7
¤CAUTION
Install this unit in the console of your vehicle.
Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot.
DDX470/DDX4070BT only
•Install the Bluetooth adapter
Bluetooth adapter
80
English