Timer operations

Timer playback of CD can be started at any time using an audio timer which is available in audio stores.

Preparation

÷Connect the power cords of the associated

 

components so that their power can be turned

 

ON through the audio timer.

 

(Also, be sure to read carefully the instruction

 

manual of the timer.)

1Turn the powers of the associated componentsON.

2Preparation

Load a disc in the CD player.

@

 

Label side

3Set the amplifier volume.

1Play the disc.

PLAY/PAUSE

6

2Adjust the amplifier volume.

(Use the remote control unit of this unit to adjust the volume to the maximum level.)

3Stop the disc.

STOP

7

This unit

 

DPF-3010/2010/1010 (En)

 

 

 

7

6

 

4

¢

 

1

¡

System control cord

Audio cord

21

Amplifier

12 F00

Audio timer

To wall AC outlet

÷If the amplifier is not connected to the CD player through a system control cord, select the “CD” input with the input selector.

Adjusting the volume:

Note Set the volume the maximum (0 dB) using the OUTPUT (UP) key on the remote control unit, and adjust the vol-

ume to the desired level on the amplifier side.

(Since the sound output is at the maximum level when the power is turned on, lowering the level with the remote control will change the volume.)

4Set the timer ON time.

Set the timer so that it supplies power at the specified time.

÷With some audio timer models, the power is automatically turned OFF when the timer ON time is set. With such a model, skip step 5 below.

5Turn OFF the power output from the audio timer.

Notes

÷Do not touch the ON/STANDBY switches of the amplifier and CD player.

÷When the set time comes, the disc playback starts automatically.

1. Some amplifiers cannot be used with a timer. Before using a amplifier, check it.

2. When operating the unit other than CD player using an audio timer, be sure to remove the disc from the CD player.