7
Connection to a general-use amplifier
Use the provided audio cords to connect the OUTPUT jacks of this unit to the CD input jacks (or AUX jacks) of the amplifier.
Connection to digital amplifier or MD (only for DPF-3010/2010)
Connect the DIGITAL OUTPUT (OPTICAL) jack to the digital input jack of the amplifier, DAT recorder, MD recorder, etc., using an optical fiber cable which are commercially available in audio stores.
÷When using an optical fiber cable to connect this unit to a digital
amplifier, insert the plug straight into the jack until a snap sound is | Optical fiber cable |
heard. |
|
÷Be careful not to bend, coil, or bundle the optical fiber cable.
÷Optical fiber cables available on the market may not always be able to be used with this player. If your cord cannot be used with this unit, consult the store from which you purchased the cord or your nearest dealer.
Adjusting the output levels of the output jacks and headphone output (only for
The OUTPUT level (UP/DOWN) keys of the remote control unit can adjust the output levels from the LINE/OUT jacks and PHONES jack
OUTPUT
DOWN UP
RC-
To use the headphone (only for
Connect a stereo headphone to the PHONES jack of the CD player. Adjust the sound volume using the remote control unit.
SINGLE TIME
_12 db
Output level
÷It is not favorable for the sound quality to decrease the output level from this unit too much. Use these keys for coordination with other line levels.
÷Adjusting the headphone output level also changes the LINE/OUT level. Do not adjust the output level from this unit particularly during recording.
÷Please note that the sound output is at the maximum level when the power is turned on.