Kenwood DPX-MP2100 Range, Range, Range, Range, Display, Display, Display, Display, Bass level, Audio Setup, Middle level, Treble level, Adjustment Item, Adjustment Item

Adjusting the detail of Audio Control

Among the Basic Audio items, you can adjust the Bass level, Middle level, and Treble level in detail.

1Select the Basic Audio item

Select the desired item to be set in detail from followings;

•Bass level

•Middle level

•Treble level

For how to select Basic Audio items, see <Audio Control> (page 6).

2Enter Detail adjustment mode of Audio ControlPress the [VOL] knob for at least 1 second.3Select the Detail Audio item to adjust Press the [VOL] knob.

Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.

4Adjust the Detail Audio item Turn the [VOL] knob.Bass level

Adjustment Item	Display	Range
Bass Center Frequency	"BAS F"	40/50/60/70/80/100/
		120/150 Hz
Bass Q Factor	"BAS Q"	1.00/1.25/1.50/2.00
Bass Extend	"B EX"	OFF/ON
Middle level
Adjustment Item	Display	Range
Middle Center Frequency	"MID F"	0.5/1.0/1.5/2.0 kHz
Middle Q Factor	"MID Q"	1.0/2.0
Treble level
Adjustment Item	Display	Range
Treble Center Frequency	"TRE"	10.0/12.5/15.0/17.5 kHz

5Exit the Detail Audio Control mode Press the [VOL] knob for at least 1 second.

⁄

•When you set the Bass Extend to ON, low frequency response is extended by 20%.

•You can exit the Audio Control mode at anytime by pressing any button except for [VOL] and [ATT] buttons.

Audio Setup

Setting the Sound system, such as Cross over Network.

1Select the source to adjust Press the [SRC] button.

2Enter Audio Setup mode

Press the [VOL] knob for at least 1 second.

3Select the Audio Setup item to adjust Press the [VOL] knob.

Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.

4Setup the Audio item Turn the [VOL] knob.

Adjustment Item	Display	Range
Front High Pass Filter	"HPF"	Through/40/60/80/100/120/
		150/180/220 Hz
Rear High Pass Filter	"HPR"	Through/40/60/80/100/120/
		150/180/220 Hz
Low Pass Filter	"LPF"	50/60/80/100/120/Through Hz
Subwoofer Phase	"PHAS"	Reverse (180°)/ Normal (0°)
Volume offset	"V-OFF"	–8 — ±0 (AUX: -8— +8)
Loudness	"LOUD"	OFF/ON

⁄

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones

during low volume. (Only the low tone is compensated for when the tuner is selected as a source.)

5Exit Audio Setup mode

Press the [VOL] knob for at least 1 second.

English 7