Kenwood IH100 manual using your induction hob, timer mode, hints

before using your induction hob for the first time

Wipe over the hob plate see ‘care & cleaning’.

key

hob plate pan guide control panel LED display

timer decrease button timer increase button timer button

on/off button power control

using your induction hob

1Plug in the induction hob. The appliance will beep and the fan will operate for a second.

2 Press the on/off button , the button will flash and the LED display

will read ––:––. It will remain with this reading unless in timer mode. The appliance is now in standby mode.

3Place the pan centrally onto the induction hob, within the pan guide - shown by the graphic on the hob plate .

4Select the desired power setting with

the power control and heating will begin.

●To adjust the power, turn the power control anticlockwise to decrease the power and clockwise to increase the power. There are 6 power settings.

●Note: When the induction hob is working, there will be a high

frequency intermittent sound and the fan will operate. This is normal.

5Turn off the induction hob when you have finished cooking by pressing the on/off button.

●The fan will continue to operate after the appliance has been switched off.

●As this induction hob operates slightly differently to a traditional hob, some adjustments to the expected cooking times and temperatures may be necessary to achieve the desired results.

hints

●To reduce the cooking time, you can turn the power control to the max position when you turn the appliance on. After a short time you can set the power control to the required position.

●After a short period of use, experience will teach you which setting is the right one for your needs.

●Pan contents heat more quickly with an induction hob.

timer mode

1 When the timer button	is pressed
it will light up, the appliance will
beep, the LED display	flashes and

shows “00:00”. Set the time using the “+” or “-” button, “+” will increase the time by 1 minute, “-” will decrease the time by 1 minute. To quickly set the time in 10 minute increments hold the “+” or “-” button down. This should be done within 5 seconds of pressing the timer button or the LED display will default back to ––:––. The timer range is

1 minute - 3 hours.

2Once the timer has been set the LED display will flash. Select the desired power level within 5 seconds (if not timing will not begin and the appliance will automatically turn off within 2 minutes). The display will then count down (indicated by the colon flashing) and heating will begin.

3After the set time has been reached, the appliance will turn off.

4