Kenwood JE720, JE730 manual Troubleshooting guide, Problem Cause and Solution

troubleshooting guide

Problem	Cause and Solution
The juicer will not operate	● Juicer not plugged in.
	● Juicer not assembled correctly. Check that:
	●	Lid latches are correcting locked in place.
	●	Pulp collector is in place and latched
		correctly.
Motor appears to slow or	● Refer to the recommended usage chart to
stop during use	check that you are using the correct speed.
	● If processing hard or fibrous foods, check
	that the pulp collector is not full and that
	there is not a build up of pulp on or around
	the filter.
	Switch off and unplug, then empty the
	pulp collector and clean the filter/holder.
Pulp too wet and low juice	● Use a slower juicing action and process
extraction	small quantities at a time.
	● Clean filter if processing very fibrous foods.
	● Refer to the recommended usage chart to
	check that you are using the correct speed.
Juice leaking between lid	● Wrong speed used. Refer to the
and pulp collector	recommended usage chart.
	● Food pushed down feed tube too fast. Use
	a slower action.
	● Check pulp collector is latched correctly.
Anti-drip spout dripping	● Ensure the majority of juice has exited the
	spout before turning to the anti-drip
	position.
Pulp falls onto the work surface	● Use a slower action when removing the
when removing the pulp	collector and make sure you slide it along
collector	the underside of the lid t o wipe the pulp
	into the collector.
	● Clear the pulp collector regularly to prevent
	an excessive build up of pulp on the lid
	and bowl chute.

6