Kenwood KAC-PS4D, KAC-X4R PROBLEM, POSSIBLE CAUSE, SOLUTION, Specifications subject to change without notice, General, No sound, CEA-2006, (Blown fuse.), Audio Section, (or too large)

Troubleshooting Guide

What might appear to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before calling service, first check the following table for possible problems.

PROBLEM	POSSIBLE CAUSE		SOLUTION
No sound.	•	Input (or output) cables are disconnected.	• Connect the input (or output) cables.
(Blown fuse.)	•	Protection circuit may be activated.	•	Check connections by referring to <Protection function>.
	• Volume is too high.		• Replace the fuse and use lower volume.
	• The speaker cord is shorted.		• After check the speaker cord and fixing the cause of the short,
				replace the fuse.
The output level is too small	•	The input sensitivity adjusting control is not set to the correct	•	Adjust the control correctly referring to <Input Sensitivity>.
(or too large).		position.
The sound quality is bad.	• The speakers wire are connected with wrong + /-polarity.		• Connect them properly checking the + / - of the terminals
(The sound is distorted.)				and wires well.
	• A speaker wire is pinched by a screw in the car body.		• Connect the speaker wire again so that it is not pinched by
				anything.
	• The switches may be set improperly.		• Set switches properly by referring to <Controls> or <DSP
				Settings>.
	•	The “OVER” indicator is lit.	•	Input level is too high. See <Input Sensitivity> and adjust.

Specifications

Specifications subject to change without notice.

CEA-2006

RMS Watts per channel @ 4 ohms, 1 % THD+N .......................................................................................................................................................................	100 W × 4
Signal to Noise Ratio (Reference: 1Watt into 4 ohms) ................................................................................................................................................................	78 dBA

Audio Section

Max Power Output.........................................................................................................................................................................................................................................	1200 W
Rated Power Output (+B = 12.0 V)
(4 Ω) (20 Hz – 20 kHz, 0.8 % THD) .......................................................................................................................................................................................	75 W × 4
(2 Ω) (1 kHz, 1.0 % THD)..........................................................................................................................................................................................................	100 W × 4
(Bridged 4 Ω) (1 kHz, 1.0 % THD) .....................................................................................................................................................................................	200 W × 2
Rated Power Output (+B = 14.4 V)
(4 Ω) (20 Hz – 20 kHz, 0.8 % THD) .....................................................................................................................................................................................	100 W × 4
(4 Ω) (DIN45324, +B = 14.4 V) .............................................................................................................................................................................................	100 W × 4
(2 Ω) (1 kHz, 1.0 % THD)..........................................................................................................................................................................................................	150 W × 4
(Bridged 4 Ω) (1 kHz, 1.0 % THD) .......................................................................................................................................................................................	300 W × 2
Frequency Response (+0, -1 dB)............................................................................................................................................................................................	20 Hz – 20 kHz
Sensitivity (rated output) (MAX.) .................................................................................................................................................................................................................	0.2 V
(MIN.) ..................................................................................................................................................................................................................	5.0 V
Input Impedance ...............................................................................................................................................................................................................................................	10 kΩ
Signal to Noise Ratio......................................................................................................................................................................................................................................	105 dB
Low Pass Filter Frequency (-24 / -12 dB/oct.)
Low Range.................................................................................................................................................................................................................................	30 – 250 Hz
High Range ...............................................................................................................................................................................................................................	500 – 5k Hz
High Pass Filter Frequency (-24 / -12 dB/oct.)
Low Range.................................................................................................................................................................................................................................	30 – 250 Hz
High Range ...............................................................................................................................................................................................................................	500 – 5k Hz
Infrasonic Filter Frequency (-24 dB/oct.) ........................................................................................................................................................	20 / 30 / 40 / 50 / 60 Hz
Built in Parametric EQ Control
Frequency BAND 1...................................................................................................................................................................................	25 / 40 / 60 / 80 / 100 Hz
Frequency BAND 2........................................................................................................................................................................	150 / 200 / 300 / 400 / 500 Hz
Frequency BAND 3.........................................................................................................................................................................	600 / 800 / 1 k / 1.5 k / 2 k Hz
Frequency BAND 4........................................................................................................................................................................................	3 k / 4 k / 5 k / 6.3 k Hz
Frequency BAND 5................................................................................................................................................................................	8 k / 10 k / 12.5 k / 16 k Hz
Quality Factor BAND 1 – BAND3......................................................................................................................................................................	1.0 / 2.0 / 3.0 / 5.0
Quality Factor BAND 4 – BAND5.......................................................................................................................................................................	2.0 / 4.0 / 8.0 / 10
Gain (Boost or Cut)............................................................................................................................................................................................................	-9 dB – +9 dB
Delay Control ........................................................................................................................................................................................................	0 ms – 3.9 ms (0.1 ms Step)
Phase Inverter .....................................................................................................................................................................................................	0° (Normal) / -180° (Reverse)

General

Operating Voltage ..............................................................................................................................................................................................	14.4 V (11 – 16 V allowable)
Current Consumption ........................................................................................................................................................................................................................................	60 A
Installation Size (W × H × D) .........................................................................................................................................................................................	340 × 60 × 225 mm
	13-3/8 × 2-3/8 × 8-7/8 inch
Weight ...................................................................................................................................................................................................................................................	3.8 kg (8.4 lbs)

English 11