Connection

2WARNING

To prevent fire caused by a short in the wiring, connect a fusible link or breaker nearby the battery’s positive terminal.

2CAUTION

•If sound is not output normally, immediately turn power off and check connections.

•Be sure to turn the power off before changing the setting of any switch.

•If the fuse blows, check wires for shorts, then replace the fuse with one of the same rating.

•Check that no unconnected wires or connectors are touching the car body. Do not remove caps from unconnected wires or connectors to prevent short circuits.

•Connect the speaker wires to appropriate speaker connectors separately. Sharing the negative wire of the speaker or grounding speaker wires to the metal body of the car can cause this unit to fail.

•After installation, check that the brake lamps, winkers, and wipers work properly.

* Commercially available parts

CENTER UNIT (CD receiver, etc.)

Power control wire

Battery wire*

Protective Fuse*

Battery

Ground wire*

RCA cable*

Left input

Right input

B channel input

A channel input

B channel

Right speaker

B channel

Left speaker

A channel

Right speaker

A channel

Left speaker

■ Bridged Connections

B channel

Speaker (Bridged)

A channel

Speaker (Bridged)

About the Lead Terminals

1Wire Thicknesses

You can use wires with the following thicknesses:

Battery wire and ground wire

AWG 4

– AWG 8

Power control wire and speaker wire

AWG 6

– AWG 18

2Strip the wire

Make a cut in the wire sheath (insulator made from vinyl, etc.) at the position 7-10 mm away from the end of the wire, and then remove the unnecessary portion of the sheath by twisting it.

3Install the wire

Loosen the screw using the supplied hexagon wrench.

Insert the conductor of the wire in the terminal hole, and then tighten the screw.

7 – 10 mm (9/32" – 3/8")

Hexagon Wrench (Large)

Hexagon Wrench (Small)

4English