CAUTION

•If sound is not output normally, immediately turn power off and check connections.

•Be sure to turn the power off before changing the setting of any switch.

•If the fuse blows, check wires for shorts, then replace the fuse with one of the same rating.

•Check that no unconnected wires or connectors are touching the car body. Do not remove caps from unconnected wires or connectors to prevent short circuits.

•Connect the speaker wires to appropriate speaker connectors separately. Sharing the negative wire of the speaker or grounding speaker wires to the metal body of the car can cause this unit to fail.

•After installation, check that the brake lamps, winkers, and wipers work properly.

7About the Lead Terminals1. Wire Thicknesses

You can use wires with the following thicknesses:

Battery wire and ground wire

AWG 4

– AWG 6

Speaker wire

AWG 8

– AWG 12

2. Strip the wire

Make a cut in the wire sheath (insulator made from vinyl, etc.) at the position 10-13 mm (3/8" - 1/2") away from the end of the wire, and then remove the unnecessary portion of the sheath by twisting it.

3. Install the wire

Loosen the screw using the supplied hexagon wrench. Insert the conductor of the wire in the terminal hole, and then tighten the screw.

 

Hexagon

 

10 - 13 mm

Wrench

Hexagon Wrench

(3/8" - 1/2")

(Large)

(Small)

 

 

English