Controls
FUSE [30Ax2] | BATT. | GND | LEFT | RIGHT | LEFT | RIGHT |
| LINE IN |
|
|
|
|
|
|
| L |
|
|
|
|
|
|
|
| R |
|
| P.CON |
| BRIDGED |
| BRIDGED |
| A | B |
|
| SPEAKER OUTPUT A | SPEAKER OUTPUT B | |||||
|
|
|
|
| ||||
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
This is a 4 channel amplifier including 2 stereo amplifiers in a body. One amplifier is referred to as amplifier A and the other is amplifier B. This unit is compatible with a large variety of systems by combining the switches and functions described in the following.
1Fuse (30 A × 2)NOTE
If you can’t find the specified capacity fuse at your store etc., consult your Kenwood dealer.
2Battery terminal3Power control terminalControls the unit ON/OFF.
NOTE
Controls the unit power. Be sure to connect it with all the systems.
4Ground terminal5Speaker output terminals (A.ch/B.ch)•Stereo Connections:When you wish to use the unit as a stereo amplifier, stereo connections are used.
The speakers to be connected should have an impedance of 2Ω or greater. When multiple speakers are to be connected, ensure that the combined impedance is 2Ω or greater for each channel.
•Bridged Connections:When you wish to use the unit as a
used. (Make connections to the LEFT channel
9and the RIGHT channel ·SPEAKER OUTPUT terminals.)
The speakers to be connected should have an impedance of 4Ω or greater. When multiple speakers are to be connected, ensure that the combined impedance is 4Ω or greater.
English