Installation

Installation

Metal mounting strap (commercially available)

Firewall or metal support

Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place.

Self-tapping screw (commercially available)

Screw (M4X8) (commercially available)

⁄

•Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip).

Removing the hard rubber frame

1Engage the catch pins on the removal tool and remove the two locks on the upper level. Upper the frame and pull it forward as shown in the figure.

Lock

Catch

Accessory2

Removal tool

2When the upper level is removed, remove the lower two locations.

⁄

•The frame can be removed from the bottom side in the same manner.

Removing the Unit

1Refer to the section <Removing the hard rubber frame> and then remove the hard rubber frame.

2Remove the screw (M4 × 8) on the back panel.

3Insert the two removal tools deeply into the slots on each side, as shown.

4Lower the removal tool toward the bottom, and pull out the unit halfway while pressing towards the inside.

Screw (M4X8) (commercially available)

Accessory2

¤

•Be careful to avoid injury from the catch pins on the removal tool.

5Pull the unit all the way out with your hands, being careful not to drop it.

24 English