Preparation
How to attach/detach the faceplate
1
1
2
2 
Do not expose the faceplate to direct sunlight, excessive heat, or humidity. Also avoid places with too much dust or the possibility of water splashing.
Keep the faceplate in its casing while detached.
The faceplate is a precision piece of equipment and can be damaged by shocks or jolts.
To prevent deterioration, do not touch the terminals of the unit and faceplate with your fingers.
How to reset your unit
If this unit fails to operate properly, press the reset button.
The unit returns to factory settings when the reset button is pressed.
Reset button
The marking of products using lasers
The label is attached to the chassis/case and says that the component uses laser beams that have been classified as Class 1. It means that the unit is utilizing laser beams that are of a weaker class. There is no danger of hazardous radiation outside the unit.
How to prepare the remote controller (RC-405)
When you use the remote controller for the first time, pull out the insulation sheet.
Insulation sheet
If the effectiveness of the remote controller decreases, replace the battery.
2 | 3 |
| |
| 4 |
1 |
|
Caution:
Do not set the remote control in hot places such as on the dashboard.
Lithium battery.
Danger of explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type.
The battery pack or batteries shall not be exposed to excessive heat such sunshine, fire or the like.
Keep battery out of reach of children and in original package until ready to use. Dispose of used batteries promptly. If swallowed contact physician immediately.
Remote controller
ENGLISH
3