Kenwood KDC-BT30, KDC-BT40U Before Using, Common Operation, Function Setting Operation, Volume, Example:, 4Make a setting, Power and source select, 5Exit Function Setting mode

General operation

Before Using

Exit of the Demonstration Mode

Turn off the demonstration mode when you use it for the first time after installation.

1Press the [VOL] knob to quit the demonstration mode when the messages “CANCEL DEMO” and “PRESS”, “VOLUME KNOB” are displayed (approx. 15 seconds).

2Turn the [VOL] knob to select “YES” and press the [VOL] knob.

⁄

•The demonstration can be set or cancel using <Demonstration Mode Setting> (page 18).

Common Operation

Power and source select

Turns the power ON by pressing the [SRC] button.

Pressing [SRC] button each time switches between sources.

Tuner (“TUNER”) ➜ USB* or iPod* (“USB” or “iPod”) ➜ CD (“CD”) ➜ Auxiliary input (“AUX”) ➜ Standby (“STANDBY”)

Keeping pressing the [SRC] button at least 1 second turns the power OFF.

⁄

•* Function is KDC-BT40U only.

•When connection of the iPod is recognized, the source display changes from “USB” to “iPod”.

•The source “CD” and “iPod” can be selected when each source is ready to play.

Volume

Turning the [VOL] knob adjusts the sound volume.

Function Setting Operation

The basic operating procedure for using this function is described below. The individual function items are covered in the operating procedures.

1Select the source Press the [SRC] button.

Function items vary from source to source. For a list of the function items. Refer to <Function Item List> (Page 30).

2Enter Function Setting mode

Press the [VOL] knob for at least 1 second. ”FUNCTION” is displayed.

3Select your desired function item

Turn the [VOL] knob and press it when the desired item is displayed.

Repeat the operation until your desired function item is selected.

⁄

Press the [ ] button to return to the previous item.

Example:

				 		
	AUDIO CONTROL
…		…	BASS BOOST
					[VOL]	[VOL]
…			DETAILED SET  
					
…			DETAIL SET
				SUPREME SET
	DISP SELECT			…

SETTINGS

In this manual, the above selection is indicated as

Select “AUDIO CONTROL” (“AUDIO CTRL”) > “DETAILED SET” (“DETAIL SET”) > “SUPREME SET”.

(“ ”) encloses a display appearing on the KDC-BT30. It is shown only if it differs from the one appearing on the KDC-BT40U.

4Make a setting

Turn the [VOL] knob to select a setting value, and then press the [VOL] knob.

5Exit Function Setting mode

Press the [ ] button for at least 1 second.

English 5