General features
Audio Setup
Setting the Sound system, such as Cross over Network.
1Select the source to adjust Press the [SRC] button.
2Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3Select the Audio Setup item to adjust Press the [VOL] knob.
Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.
4Setup the Audio item Turn the [VOL] knob.
Adjustment Item | Display | Range |
Front High Pass Filter*2 | "HPF" | Through/80/100/120/150/ |
|
| 180 Hz |
Rear High Pass Filter*2 | "HPR" | Through/80/100/120/150/ |
|
| 180 Hz |
Low Pass Filter*1,2 | "LPF" | 60/80/120/Through Hz |
Subwoofer Phase*1,2,3 | "PHAS" | Reverse (180°) / Normal (0°) |
Volume offset | ||
Loudness | "LOUD" | OFF/ON |
•Volume offset: Sets each source’s volume as a difference from the basic volume.
•Loudness: Compensates for low and high tones during low volume.
•*1 You can control this item when <Subwoofer Output> (page 11) is set to "SW ON".
•*2 Function of the
•*3 You can control this item when Low Pass Filter is not set to Through.
5Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.
Speaker Setting
1Enter Standby
Press the [SRC] button. Select the "STANDBY" display.
2Enter Speaker Setting mode Press the [VOL] knob.
3Select the Speaker type Turn the [VOL] knob.
Each time you turn the knob, the setting alternates between the settings shown in the table below.
Speaker type | Display | |
OFF |
| "SP OFF" |
For 5 | & 4 in. speaker | "SP 5/4" |
For 6 | & 6x9 in. speaker | "SP 6*9/6" |
For the OEM speaker | "SP OEM" | |
4Exit Speaker Setting mode Press the [VOL] knob.
10 English