Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit so that it does not fall off.
1Refer to the section <Removing the hard rubber frame> (page 32) and then remove the hard rubber frame.
2Drop open the faceplate by pressing the Release button.
3Tighten the screw (ø2 × 5 mm) (Accessory5) and bracket (Accessory 6) in the hole shown on the diagram.
Accessory6
Accessory5
4Tighten the screw (ø2 × 5 mm) (Accessory5) and bracket (Accessory7) in the hole shown on the diagram.
Accessory7
Accessory5
•Never insert the screws in any other screw hole than the one specified. If you screw them in another hole, it will contact and may cause damage to the mechanical parts inside the unit.
English 31