Troubleshooting Guide
The messages shown below display your systems condition.
TOC ERROR: | • No disc has been loaded in the disc | |
| magazine. | |
| • The CD is quite dirty. The CD is upside- | |
| down. The CD is scratched a lot. | |
The disc is unreadable. | ||
The unit is malfunctioning for some reason. | ||
| ¢ | Press the reset button on the unit. If the "E- |
|
| n" code does not disappear, consult your |
|
| nearest service center. |
Something is wrong with the disc magazine. | ||
| Or the unit is malfunctioning for some reason. | |
| ¢ | Check the disc magazine. And then press |
|
| the reset button on the unit. If the |
|
| code does not disappear, consult your |
|
| nearest service center. |
IN (Blink): | The CD player section is not operating | |
| properly. | |
| ¢ | Reinsert the CD. If the CD cannot be |
|
| ejected or the display continues to flash |
|
| even when the CD has been properly |
|
| reinserted, please switch off the power |
|
| and consult your nearest service center. |
PROTECT: | The speaker wire has a | |
| touches the chassis of the vehicle, and then | |
| the protection function is activated. | |
| ¢ | Wire or insulate the speaker cable |
|
| properly and press the reset button. If |
|
| the "PROTECT" code does not disappear, |
|
| consult your nearest service center. |
NA FILE: | An Audio file is played with a format that this | |
| unit can'tsupport. | |
COPY PRO: | A | |
READ ERROR: | The file system of the connected USB device | |
| is broken. | |
| ¢ | Copy the files and folders for the USB |
|
| device again. If the error message is still |
|
| displayed, initialize the USB device or use |
|
| other USB devices. |
NO DEVICE: | The USB device is selected as a source | |
| although no USB device is connected. | |
| ¢ | Change the source to any source other |
than USB. Connect an USB device, and change the source to USB again.
N/A DEVICE: An unsupported USB device is connected.
¢Remove the USB device without entering the remove mode.
NO MUSIC
•The connected USB device contains no playable audio file.
•Media was played that doesn'thave data recorded that the unit can play.
USB ERROR/USB (Blink):
Some trouble may have occurred to the connected USB device.
¢Remove the USB device, then cycle the power switch to ON. If the same display is repeated, use another USB device.Remove the USB device without entering the remove mode.
iPod ERROR: Connection to the iPod has failed.
¢Check that the connected iPod is an iPod that is supported. See <About Audio file> (page 16) for information on supported iPods.
¢Remove the USB device and then reconnect it.
¢Confirm that the software for the iPod is the latest version.
USB REMOVE: The Remove mode has been selected for the USB device/iPod. You can remove the USB device/iPod safely.
