English
— 48 —
Troubleshooting Guide
SOLUTIONPOSSIBLE CAUSEPROBLEM
Can’t remove disc. The cause is that more than 10 minutes has elapsed
since the vehicle ACC switch was turned OFF.
The disc can only be removed within 10 minutes of the
ACC switch being turned OFF. If more than 10 minutes
has elapsed, turn the ACC switch ON again and press
the Eject button.
A CD ejects as soon as it is
loaded.
The CD is upside-down. Load the CD with the labeled side up.
The CD is quite dirty. Clean the CD, referring to the section on "Cleaning CDs"
(see p. 5).
The sound skips on a CD. The CD is scratched or dirty. Clean the CD, referring to the section on "Cleaning CDs"
(see p. 5).
A track will not play. Random play has been selected. Turn off random play.
No sound can be heard, or the
volume is low. The fader or balance settings are set all the way to one
side.
Reset the fader or balance settings.
The input/output wires or wiring harness are connected
incorrectly.
Reconnect the input/output wires or the wiring harness
correctly. See the section on "Connecting Wires to
Terminals".
Attenuator is turned on. Turn off Attenuator.
The values of Volume offset are low. Increase the values of Volume offset. (see p. 18)
One of the speaker wires is being pinched by a screw in
the car.
Check the speaker wiring.
The sound quality is poor or
distorted.
The speakers are not wired correctly. Reconnect the speaker wires so that each output
terminal is connected to a different speaker.
KDC-PS9018R(M_E)_r3 2003.06.13 03:04 PM Page 48