General features

Audio Setup

Setting the Sound system, such as Cross over Network.

1Select the source to adjust Press the [SRC] button.

2Enter Audio Setup modePress the [VOL] knob for at least 1 second.3Select the Audio Setup item to adjust Press the [VOL] knob.

Each time you press the knob, the item to be adjusted alternates between the items shown in the table below.

4Setup the Audio item Turn the [VOL] knob.

Adjustment Item

Display

Range

Front High Pass Filter*2

"HPF-F"

Through/40/60/80/100/

 

 

120/150/180/220 Hz

Rear High Pass Filter*2

"HPF-R"

Through/40/60/80/100/

 

 

120/150/180/220 Hz

Low Pass Filter*1,2

"LPF"

50/60/80/100/120/ Through

 

 

Hz

Subwoofer Phase*1,2,3

"SW Phase"

Normal (0°)/ Reverse (180°)

Volume offset

"VOL Offset"

–8 — ±0

Loudness

"Loudness"

ON/OFF

Dual Zone System

"2Zone"

ON/OFF

•Volume offset: Sets each source’s volume as a difference from the basic volume.

•Loudness: Compensates for low and high tones during low volume.

•*1 You can control this item when <Switching preout> (page 33) is set to "SWPRE:Sub-W". (KDC-W707 only)

•*1 You can control this item when <Subwoofer Output> (page 12) is set to "SW ON".

•*2 You can control this item when "2Zone" of <Audio Setup> (page 12) is set to "OFF".

•*3 You can control this item when Low Pass Filter is not set to Through.

•Dual Zone System

Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.

-Set up the channel of sub source by <Dual Zone System Setting> (page 34).

-Select Main source by [SRC] button.

-Adjust the volume of Front channel by [VOL] knob.

-Adjust the volume of Rear channel by <Audio Control> (page 11).

-The Audio Control has no effect on sub source.

•You can use the Dual Zone System with the Auxiliary input sources listed below.

-Internal auxiliary input (KDC-W808 only)

-Option CA-C1AX (KDC-W707 only)

5Exit Audio Setup modePress [VOL] knob for at least 1 second.

Subwoofer Output

Turning the Subwoofer output ON or OFF.

Hold down on [AM] of the Control knob for at least 1 second.

Each time you press the button, Subwoofer output switches ON and OFF.

When it is ON, "SW ON" is displayed.

•You can control this function when <Switching preout> (page 33) is set to "SWPRE:Sub-W". (KDC- W707 only)

•You can control this function when "2Zone" of <Audio Setup> (page 12) is set to "OFF".

12 English