Installation

Installation

Metal mounting strap (commercially available)

Firewall or metal support

Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place.

Self-tapping screw (commercially available)

Screw (M4X8) (commercially available)

•Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip).

•To attach this unit, make sure the front of the control panel faces you and fit it into the mounting sleeve by pressing the four corners of the hard rubber frame at the same time.

Do not apply strong pressure to other sections than the corners; otherwise troubles such as the impossibility of opening or closing the panel may result.

Screwing the Faceplate on the Unit

If you want to fasten the faceplate to the main unit so that it does not fall off, screw in the provided screws in the holes shown below.

1Refer to the function <Theft Deterrent Faceplate> (page 19) and remove the faceplate.

2Insert the provided screw into the hole at the center of the bottom side of the faceplate which you have removed from the unit.

Accessory4

3Refer to the section <Theft Deterrent Faceplate> (page 19) and then reattaching the faceplate.

•Never insert the screw in any other screw hole than the one specified. If you screw them in another hole, it will contact and may cause damage to the mechanical parts inside the unit.

English 43