Menu system

In Standby mode

Security Code

Because authorization by the Security Code is required when the audio unit is removed from the vehicle, personalizing this unit by using the Security Code is helpful in preventing theft.

•Setup Security Code when the <Demonstration mode Setting> (page 39) is set as OFF.

•When you activate the Security Code function, it cannot be released.

Note, your Security Code is the 4 digit number entered in your "Car Audio Passport" in this package.

1Enter Standby

Press the [SRC] button. Select the "STANDBY" display.

2Enter Menu mode

Press the [MENU] button for at least 1 second. When "Menu" is displayed, "Security" is displayed.

3Enter Security Code mode

Press the Control knob for at least 1 second. When "Enter" is displayed, "CODE" is also displayed.

4Select the digits to enter

Push the Control knob towards [4] or [¢].

5Select the Security Code numbersPush the Control knob towards [FM] or [AM].6Repeat steps 4 and 5, and complete the Security Code.7Confirm the Security Code

Press the Control knob for at least 3 seconds. When "Re-Enter" is displayed, "CODE" is also displayed.

8Do the step 4 through 7 step operation, and reenter the security code.

"Approved" is displayed.

The Security Code function activates.

•If you enter a Code different from your Security Code, you have to start over from step 4.

Press the Reset button when the audio unit is removed from the battery power source

1Turn the power ON.

32 English

2Do the step 4 through 7 step operation, and reenter the security code.

"Approved" is displayed.

You can begin using the unit.

•If an incorrect code is entered, "WAITING" is displayed, and the input prohibition periods shown in the table below is generated.

After the input prohibition time lapses, "CODE" is displayed, and you can reenter the code.

Number of times theInput prohibited time

incorrect code was input

 

1

—

2

5 minutes

3

1 hour

4

24 hours

In Standby mode

Touch Sensor Tone

Setting the operation check sound (beep sound) ON/OFF.

Display

Setting

"Beep:ON"

Beep is heard.

"Beep:OFF"

Beep canceled.

In Standby mode

Manual Clock Adjustment

•You can do this adjustment when the <Synchronize Clock> (page 33) is set as OFF.

1Select Clock Adjustment modePush the Control knob towards [FM] or [AM]. Select the "Clock Adjust" display.2Enter Clock Adjust modePress the Control knob for at least 1 second. The clock display blinks.3Adjust the hours

Push the Control knob towards [FM] or [AM].

Adjust the minutes

Push the Control knob towards [4] or [¢].