Kenwood KDCBT7043U non-Japanesecars, Japanese cars, Removing the hard rubber frame, Removing the Unit, T N, N T, T/N, English |, the inside, on each side, as shown

Installation/Removing the Unit

non-Japanese cars

Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place.

⁄

•Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (for example, the sound may skip).

Japanese cars

1Refer to the section <Removing the hard rubber frame> and then remove the hard rubber frame.

2Align the holes in the unit (two locations on each side) with the vehicle mounting bracket and secure the unit with the accessory screws.

T N

Removing the hard rubber frame

1Engage the catch pins on the removal tool and remove the two locks on the upper level. Upper the frame and pull it forward as shown in the figure.

Lock

Catch

Accessory2

Removal tool

2When the upper level is removed, remove the lower two locations.

⁄

•The frame can be removed from the bottom side in the same manner.

Removing the Unit

1	Refer to the section <Removing the hard rubber
2	frame> and then remove the hard rubber frame.
	Insert the two removal tools deeply into the slots
	on each side, as shown.

N T

8 mm

T/N

T: Toyota cars

N: Nissan cars

3 Lower the removal tool toward the bottom, and

pull out the unit halfway while pressing towards

the inside.

Accessory2

MAX.8mm

MAX.

3 4

ø5mmø5mm

Accessory3...for Nissan car

Accessory4...for Toyota car

¤CAUTION

Install this unit in the console of your vehicle. Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot.

¤

•Be careful to avoid injury from the catch pins on the removal tool.

4Pull the unit all the way out with your hands, being careful not to drop it.

English 35