Adjusting the detail of Audio Control
You can adjust the following Basic Audio Items in datail: Bass level, Middle level, and Treble leval.
Bass levelAdjustment Item |
| Display |
| Range |
Bass Center Frequency |
| “BASS F” | 40/50/60/70/80/100/ | |
|
|
|
| 120/150 Hz |
Bass Q Factor |
| “BASS Q” | 1.00/1.25/1.50/2.00 | |
Bass Extend |
| “BASS EXT” |
| OFF/ON |
Middle level |
|
|
|
|
|
|
|
|
|
Adjustment Item |
| Display |
| Range |
Middle Center Frequency |
| “MID F” |
| 0.5/1.0/1.5/2.0 kHz |
Middle Q Factor |
| “MID Q” | 1.0/2.0 | |
Treble level |
|
|
|
|
|
|
|
|
|
Adjustment Item |
| Display |
| Range |
Treble Center Frequency |
| “TRE F” |
| 10.0/12.5/15.0/17.5 kHz |
Press the [AUD] knob for at least 1 second.
3Select the Detail Audio item to adjust Press the [AUD] knob.4Adjust the Detail Audio item Turn the [AUD] knob.5Exit the Detail Audio Control mode Press the [AUD] knob for at least 1 second.⁄
•When you set the Bass Extend to ON, low frequency response is extended by 20%.
•You can exit the Audio Control mode at anytime by pressing any button except for [AUD] knob or [0] button.
Audio Setup
You can set Sound system , such as follows;Adjustment Item |
| Display |
| Range |
Front High Pass Filter |
| “HPF F” |
| Through/40/60/80/100/120/ |
|
|
|
| 150/180/220 Hz |
Rear High Pass Filter |
| “HPF R” |
| Through/40/60/80/100/120/ |
|
|
|
| 150/180/220 Hz |
Low Pass Filter |
| “LPF SW” |
| 50/60/80/100/120/ Through |
|
|
|
| Hz |
Subwoofer Phase |
| “SW PHASE” |
| Reverse (180°)/ Normal (0°) |
Volume offset |
|
| ||
Dual Zone System |
| “2ZONE” |
| OFF/ON |
⁄
•Volume offset: Sets each source’s volume as a difference from the basic volume.
•Dual Zone System
Main source and sub source (Auxiliary input) output Front channel and Rear channel separately.
-Set up the channel of sub source by “ZONE2” of <Function Control> (page 6).
-Select Main source by [SRC] button.
-Adjust the volume of Front channel by [AUD] knob.
-Adjust the volume of Rear channel by <Audio Control> (page18) or [5]/[∞] button on the remote control (page 28).
-The Audio Control has no effect on sub source.
1Select the source to adjust Press the [SRC] button.
2Enter Audio Setup modePress the [AUD] knob for at least 1 second.
3Select the Audio Setup item to adjust Press the [AUD] knob.4Adjust the Audio setup item Turn the [AUD] knob.5Exit Audio Setup modePress the [AUD] knob for at least 1 second.
English 19