![](/images/new-backgrounds/1067531/675317x1.webp)
KENWOOD CHEF AND MAJOR KM001 – KM006 series
troubleshooting
problem
●The whisk or
solution ● Adjust the height. Here’s how:
1Unplug.
2Raise the mixer head and insert the whisk or beater.
3Hold it, then loosen the nut
4Lower the mixer head.
5Adjust the height by turning the shaft. Ideally the
6Raise the head, hold the
problem
●The mixer stops during operation.
solution ● Your mixer is fitted with an overload protection device and will stop if overloaded to protect the machine. If this happens, switch off and unplug the mixer. Remove some of the ingredients to reduce the load, and allow the mixer to stand for a few minutes. Plug in and reselect the speed. If the mixer does not restart immediately allow to stand for additional time.
to fit and use your splashguard
1Raise the mixer head until it locks.
2Fit the bowl onto the base.
3Push the splashguard on until fully located The food chute should be
positioned as shown .
4Insert required tool.
5Lower the mixer head.
6 Fit the food chute cover .
●During mixing the chute cover can be remove and ingredients added
directly to the bowl .
●You do not need to remove the splashguard to change tools.
7Remove the splashguard by raising the mixer head and sliding it down.
CHEF
1
min
0
P
3 2
1
in m
0
P
3 2
1
in m
0
P
3