MD/External disc control features
English
Store the names of discs to be displayed when played.
1Play the disc whose name you want to preset.
NOTE
•This function is not available for disc changers that do not feature the Disc Name Preset function.
•This procedure is not to be used to store the disc and track titles for MDs that you record.
•The disc name preset function cannot be used when a disc title name or track title is displayed.
2Hold down the NAME.S button for two seconds or more. "NAME SET" is displayed and the disc name preset mode is entered.
The cursor blinks in the position where character input can be made.
3Press either the 4 or ¢ button to move the cursor to the desired position.
The 4 button moves the cursor to the left, and the ¢ button to the right.
4Each time the TI button is pressed, the characters to be
entered change as listed below.
Press the DISC+ or DISC– button to display the desired character.
Characters that can be displayed are as follows.
Alphabet (upper case): A ~ Z
Alphabet (lower case): a ~ z
Numerals and symbols: 0~9 @ ” ‘ ` % & ∗ + - = , . / \ < > [ ]
Special characters: á à é è í ì ó ò ú ù Ñ ëî ï ô ö û ü ñ ç © Æ ›
NOTE
The operation and characters that can be entered may change as listed below, depending on the unit that is connected.
A press of the TI button exits the disc name preset mode.
Operations can be followed again from Step 2 at a time such as this, and the characters to be input are selected using the procedure described below.
Press the DISC+ or DISC– button to display the desired character. Besides the alphabet (capital letters only) and numbers, you can choose the following characters: /, +,
5Continue steps 3 and 4 until all the characters are chosen for the name.
NOTE
You can enter up to eight characters for each name.
6Press the NAME.S button.
The disc name is stored and the disc name preset mode is cancelled.
If you make no entry in a
NOTE
•The number of characters and discs whose names can be stored will differ depending on the disc changer that is connected. Please see your disc changer manual for details.
•Discs are identified by their total length and number of tracks. If another disc happens to have the same specifications as one that you have already stored a name for, the name will be displayed for it, too.
•If you want to change the name of a disc, repeat steps 1 and 2 to display the name, and then repeat steps 3 and 4 to input the changes.
•Pressing the reset button does not erase the disc names stored in a disc changer.
— 20 —