The backlight flashes twice.
ENT
POWER
DISPLAY
0
8
REPEAT
5
2
THEME

4Enter the setup code.

MENUFAV

13

TV/SAT/VID INFO

ALT AUD

46

+100RANDOM

79

Getting the most from your remote control

KR-V888D (En/T)

3 9

•Example: Press 5258 to register a LD player made by KENWOOD.

•The backlight flashes once each time a number is entered.

•If an invalid setup code is entered the remote will output one long blink, disregard that code and return to the beginning of step 4.

•If you push an invalid key, the remote will exit the setup mode.

5Press POWER, and check to see that the component you want to control turns on.

• PLAY or TUNING/SKIP (+/–) can also be used instead of POWER.

• If the component does not react, and there is more than one setup code, enter another setup code and try again.

• If the component is already on, pressing POWER will turn it off.

6Press the ENT key to store the code you have just input.

• This code replaces any previous setup codes entered for the respective component.

 

• If you have components that are not remote controllable, like a record

7Repeat steps 3 to 6 to register additional

player (etc.), you will need to register a dummy code at the respective

input. This keeps the respective input in the remote control's cyclic list

so you can select it using the remote control. Please consult the

components until all components have been

owner's manual of the components you are connecting for information

registered.

regarding remote controllability. The list of dummy codes is included at

8Once setup codes have been entered for all

the beginning of the Set up code chart.

i

 

 

components, hold down the ENT key until

 

 

the backlight flashes twice.

• This operation should take about 3 seconds.

 

 

• Once registered, the display on the receiver shows the component

 

type instead of the default input name.

 

 

Example: if you register a VCR at the VIDEO 1 jacks, "VCR" appears

 

instead of "VIDEO 1(SAT)".

 

ENT

• Both the default input name and the component type (i.e., " VIDEO1

 

'VCR' ") are shown in the on screen display when the OSD mode is set

 

to ON.

fl

 

• After initial setup, any VIDEO (VIDEO 1, 2, 3) or TV (TV1, TV2, CABLE)

 

inputs that have not been programmed with a setup code or Non-IR

 

code are deleted from the cyclic list (except for the "AV AUX" VIDEO

 

input). The PHONO input will be deleted if a Non-IR code was not

 

registered.

 

 

• The INPUT SELECTOR on the front panel of the receiver always cycles

 

through all inputs.

 

 

 

Although each setup code is designed to work with a number of different models, certain codes may not work with some models. (Also,

Note

certain codes may only operate some of the functions available on a given model.)

Remote Control