Kenwood KR-V888D Setup code correlation

Getting the most from your remote control

KR-V888D (En/T)

4 5

Keys or controls used in this operation.

Deleting a setup code

1Hold down the ENT key until the backlight flashes twice.

2Select the component to be deleted.

Press the VIDEO, AUDIO, or TV key repeatedly to select the desired component.

3Enter the 3 digit code "991".

4Hold down the ENT key until the backlight flashes twice.

•At this time all inputs become available regardless of any earlier registration.

•Example 1 : To delete the registration of the component connected to the VIDEO 1 jacks, select "VIDEO 1".

Perform each step within 5 seconds.

• To resume the factory settings, proceed step 1, then enter “981”.

Checking a setup code

1Hold down the ENT key until the backlight flashes twice.

2Select the component with setup code you want to check. Press the VIDEO, AUDIO, or TV key repeatedly to select the desired component.

3Enter the 3 digit code "990".

4Press the 1 key and count the number of times the backlight blinks. This is the first number of the 4 digit setup code.

5Press the 2 key and count the number of times the backlight blinks. This is the second number of the 4 digit setup code.

6Press the 3 key and count the number of times the backlight blinks. This is the third number of the 4 digit setup code.

7Press the 4 key and count the number of times the backlight blinks. This is the fourth number of the 4 digit setup code.

•The backlight flashes twice immediately after the "0" is input to confirm input.

•If the backlight does not blink, the first digit in the setup code is 0.

•If the backlight does not blink, the second digit in the setup code is 0.

•If the backlight does not blink, the third digit in the setup code is 0.

•If the backlight does not blink, the fourth digit in the setup code is 0.

Remote Control

Perform each step within 5 seconds.