Basic operations of remote control (See page 8)

Optional

2CAUTION

 

NOTE

English

Do not set the remote control on hot places such as above the fascia panel (dashboard).

Replacing the Lithium Battery:

Use one lithium battery (CR2025).

Remove the case following the instructions as illustrated.

To open

Keep on slide 1 Pull out.

2

Insert the battery with the + and poles aligned properly, following the illustration inside the case.

2WARNING

Store unused lithium batteries out of the reach of children. Contact a doctor immediately if the battery is accidentally swallowed.

NOTE

A portion of the operations may not be possible, depending on the unit that is connected.

All Modes

VOL. buttons

Keep on pressing the ubutton to turn the volume up. keep on pressing the dbutton to turn the volume down.

TUNER button

Selects the tuner mode.

TAPE button

Selects the tape mode.

CD•MD CH button

Selects the disc control mode.

The disc control mode will differ depending on the unit that is connected.

Tuner Mode

Number/ letter entry buttons

Press buttons #1-6 to recall preset stations.

During direct access tuning, use these buttons to input the frequency of the station.

TUNE buttons

Press the 4 button to make decreasing seeks (using the preset tuning mode).

Press the ¢ button to make increasing seeks (using the preset tuning mode).

AM/FM button

Press the AM button to select the MW and LW bands.

Press the FM button to select and switch between FM1, FM2, and FM3 bands.

DIRECT/OK button

Selects the direct access tuning mode, used to input frequencies directly. Press this button again to cancel the mode whilst it is operating.

During Station name preset play mode, selects station.

DNPP button

Enters and cancels the Station Name Preset Play mode.

Tape Mode

T.ADV buttons

Press the 4 button to start play again at the beginning of the current track.

Press the ¢ button to start play at the beginning of the next track.

REW button

Rewinds the tape.

FF button

Fast forwards the tape.

— 36 —