Kenwood KRF-V5010, KRF-V6010, KRF-V7010 Setting up the system, Connecting audio components, MONITO￿R￿ kHz, RC6, VIDEO, MONITOR, MONITOR, CD player, MD recorder, Record player, VIDEO 2/MONITOR

Setting up the system

Make connections as shown below.

8 When connecting the related system components, be sure to also refer to the instruction manuals supplied with the components you are connecting.

Do not connect the power cord to a wall outlet until all connections are completed.

	Microcomputer malfunction
Preparations	If operation is not possible or an erroneous display appears, even
	though all connections have been made properly, reset the micro-
	computer referring to “In case of difficulty”.	￿

Caution regarding placement

To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions, including projections) equal to, or greater than shown below:

Left and right panels: 10 cm, Rear panel: 10 cm, Top panel: 50 cm

KRF-V7010/V6010/V5010 (En/T)

Connecting audio components

Shape of AC outlets

For U.K.

For other countries

SYSTEM CONTROL jacks 0To AC wall outlet

VIDEO 2/MONITOR jacks

The receiver’s VIDEO 2/MONITOR jacks can be used in two different ways. Make the appropriate setting for the component connected to the jack when the receiver is turned on.

Use as a VIDEO 2 jack

You can connect a video deck or the like to these jacks and perform video playback and recording. The initial factory setting is “VIDEO 2” .

Use as a MONITOR jack

You can connect a cassette deck or the like to these jacks and make use of the deck’s monitoring function during recording. Alternately, you can connect a graphic equalizer to these jacks to apply compensation to the music signal.

To use the VIDEO 2/MONITOR jacks as MONITOR jacks, hold down the VIDEO 2/MONITOR key of the main unit for more two seconds so that the indication shown below appears.

VIDEO 2/MONITOR

			MONITO￿R￿ kHz	DOWNMIX	DSP	TUNED
SP A B	L	R	FM	AUTO SOUND DIGITAL		AUTO
MUTE		SW	AM PRO LOGIC S.DIRECT MEMO.
			MHz	STEREO	MONITOR	ST.

•At the same time the setting is switched to “MONITOR,” the audio input source switches to tuner and the video input source switches to VIDEO 1.

•To switch the setting back to “VIDEO 2,” once again hold down the VIDEO 2/MONITOR key for two seconds or more.

•If you decide to use the VIDEO 2/MONITOR jacks as MONITOR jacks, make sure to delete the “VIDEO 2 (VCR2)” input from the

preset remote control (RC-R0507). RC6

Notes

1.Connect all cords firmly. Loose connections may prevent proper sound transmission or produce noise.

2.Be sure to remove the power cord from the AC outlet before plugging or unplugging any connection cords. Plugging / unplugging connec- tion cords without disconnecting the power cord can cause malfunc- tions and may damage the unit.

3.Do not connect power cords from components whose power con- sumption is larger than what is indicated on the AC outlet at the rear

of this unit.

REC OUT PLAY IN REC OUT PLAY IN

L

R

PHONO CD MD / TAPE VIDEO 2 / MONITOR

IN	OUT
Cassette deck or
graphic equalizer		^

To use these jacks as MONITOR jacks, you must change the appropriate setting.

OUT

Cassette deck or

MD recorder

IN

OUT

CD player

OUT

Record player

To use the receiver for video recording, connect a video deck to the VIDEO 2/MONITOR jacks.