Kenwood KRF-V5010, KRF-V6010, KRF-V7010 Presetting radio stations manually, Receiving preset stations, Receiving preset stations in order (P.CALL), AUDIO, TUNER, MEMORY, MEMORY, 1-0,+10, 1-0,+10

Presetting radio stations manually

The RDS auto memory function assigns preset numbers to RDS stations starting from preset number "1". Therefore, be sure to execute the RDS auto memory function before using the following operations to manually store AM stations and other FM stations, and RDS stations.

“Presetting RDS stations (RDS AUTO MEMORY)”.

MEMORY

MULTI CONTROL

1Tune to the station you want to store.2Press the MEMORY key while receiving the station.Proceed to step 3 within 5 seconds.(If more than 5 seconds elapse, press the MEMORY key again).

•When storing radio stations manually, it may take a few seconds before the "MEMORY" indicator appears in the display after press- ing the MEMORY key depending on receiving conditions.

Blinks for 5 secondsLights for 5 seconds

			01 98.	))	TUNED
SP A	L	R		FM	AUTO
		SW			MEMO.
		SW		MHz STEREO	ST.

3Use the MULTI CONTROL to select one of the station presets (1 – 30).

4Press the MEMORY key to accept the setting.

•Repeat steps 1, 2, 3 and 4 to store as many stations as necessary.

•If you store a station at a previously used preset, the old station will be replaced by the new one.

Receiving preset stations

AUDIO

1-0, +10

TUNER

1-0, +10

RC-R0507

RC-R0307

1Use the remote control to select the tuner as the source.

Listening to radio broadcasts

KRF-V7010/V6010/V5010 (En/T)

2Enter the number of the preset you want to receive (up to "30").

Press the numeric keys in the following order:

For "15", press ..........	0,5
For "20", press ..........	0,0,)

•If you make a mistake entering a two digit number, press the +10 key several times to return to the original display and start again.

			15 98.	))	TUNED
SP A	L	R		FM	AUTO
		SW		MHz STEREO	ST.

Receiving preset stations in order (P.CALL)

AUDIO
P.CALL	TUNER
	TUNER	Operations
	P.CALL	Operations
	P.CALL
RC-R0507		RC-R0307

1Use the remote control to select the tuner as the source.

• The remote control switches to the tuner operating mode.

2Use the P.CALL key to select the desired station.

•Each time you press the key, another preset station is received in order.

Pressing the P.CALL (%) key (¢) does the following: 01=02=03= ...... 28=29=30=01=02=03=

Pressing the P.CALL (ﬁ) key (4) does the following: 01+02+03+ ...... 28+29+30+01+02+03+

Holding down the key, lets you skip through the presets, receiving each for 0.5 seconds apiece.

• The remote control switches to the tuner operating mode.