Kenwood KRF-V7050D, VR-507 Operation, Speaker placement, Setting up the system, For VR-507 (RC-R0720), Loading the batteries, Loading the batteries, Channel space switching

Speaker placement

Center speaker

Preparations	Front	Subwoofer
		Subwoofer
	speaker	Listening
		Listening
	Surround	position
	Surround
	speaker

Front speakers : Place to the front left and right of the listening position. Front speakers are required for all surround modes.

Center speaker : Place front and center. This speaker stabilizes the sound image and helps recreate sound motion. Be sure to connect a center speaker when using the Dolby 3 Stereo mode.

Surround speakers : Place to the direct left and right, or slightly behind, the listening position at even heights, approximately 1 meter above the ears of the listeners. These speakers recreate sound motion and atmosphere. Required for surround playback.

Subwoofer : Reproduces powerful deep bass sounds.

•Although the ideal surround system consists of all the speakers listed above, if you don't have a center speaker or a subwoofer, you can divide those signals between the available speakers in the speaker

settings steps to obtain the best possible surround reproduction from

the speakers you have available.

(

Channel space switching

(Except for the USA, Canada, UK, Europe, and Australia)

The space between radio channels has been set to the one that prevails in the area to which the system is shipped. However, if the current channel space setting does not match the setting in the area where the system is to be used, for instance when you move from area 1 or area

Setting up the system

Preparing the remote control

For VR-507 (RC-R0720)Loading the batteries

1 Remove the cover.

2 Insert the batteries.

3Close the cover.

• Insert two AA-size (R6) batteries as indicated by the polarity markings.

For KRF-V7050D (RC-R0613)

Loading the batteries

1 Remove the cover.

2 Insert the batteries.

3Close the cover.

• Insert two AA-size (R6) batteries as indicated by the polarity markings.

Operation

When the STANDBY indicator is lit, the power turns ON when you press the POWER key on the remote control. When the power comes ON, press the key you want to operate.

Operating range

2 shown in the following table or vice versa, proper reception of AM/FM broadcasts cannot be expected. In this case, change the channel space setting in accordance with your area by referring to the following table.

(Approx.)

Remote sensor

	Area	CHANNEL
	Area	Space Frequency
		Space Frequency

1	USA, Canada and South	FM: 100 kHz
1	American countries	AM: 10 kHz
	American countries	AM: 10 kHz

2	Other countries	FM: 50 kHz
2	Other countries	AM: 9 kHz
		AM: 9 kHz

75∝S

AM 10KHZ FM 100KHZ

50∝S	A
AM 9KHZ	R
FM 50KHZ

DE-

DE-EMPHASIS

CHANNEL

SPACE

EMPHASIS

CHANNEL

SPACE

Move switch lever to match your area with a small screwdriver or other pointed tool.

6 m

Infrared ray system

•When pressing more than one remote control key successively, press the keys securely by leaving an interval of 1 second or more between keys.

Notes

1.The supplied batteries may have shorter lives than ordinary batteries due to use during operation checks.

2.When the remote-controllable distance gets shorter than before, replace both batteries with new ones.

3.Placing the remote sensor in direct sunlight, or in direct light from a high frequency fluorescent lamp may cause a malfunction.

In such a case, change the location of the system installation to prevent

malfunction.