Kenwood KRF-V8010D Connecting the DVD 6-channeljacks

Input mode settings

The VIDEO2 and VIDEO3 inputs each include jacks for digital audio input and analog audio input.

You must select beforehand which type of input is to be used for each connected component. The initial factory setting is to use the digital audio signal for playback.

To use the analog audio input for playback instead (if, for example, you have connected a VCR to the VIDEO2 or VIDEO3 input), you must set the input mode for the corresponding input to the analog mode. After completing connections and turning on the receiver, follow the steps below.

INPUT SELECTOR

INPUT MODE

1Use the INPUT SELECTOR knob to select either VIDEO2 or

VIDEO3.

2Press the INPUT MODE key.

Each press switches the setting as follows:

1 D-AUTO(digital input, auto sound)

2 D-MANUAL(digital input, manual sound)

3 ANALOG (analog input, manual sound)

4 DVD 6ch (this appears in the display only when set) When DVD 6ch is selected, you cannot use the SPEAKER B, BASS BOOST, MONITOR, SOURCE DIRECT, LISTEN MODE, SOUND, and SET UP keys.To use these keys, select

an input mode other than DVD 6ch.

Digital input:

Select this setting to play digital signals from a DVD, CD, or LD player.

Analog input:

Select this setting to play analog signals from a cassette deck, VCR, or turntable. Also, select this setting to listen to DVD 2-channel signal in analog format.

DVD 6ch input:

The 6-channel signal sent from the DVD player is played as is.

Auto sound:

In the auto sound mode (AUTO SOUND indicator lights), the receiver selects the listening mode automatically during playback to match the type of input signal (Dolby Digital, PCM, etc.) and the speaker setting. The initial factory setting is auto sound on.

To keep the receiver set to the currently selected listening mode, use the INPUT MODE key to select “D-MANUAL” (manual sound). However, even when this setting is selected, there may be cases in which the listening mode is selected automatically to match a Dolby Digital source signal depending on the combination of listening mode and source signal.

Setting up the system

KRF-V8010D (En/T)

DVD 6 channel input mode settings

When connecting a DVD player with 6-channel output jacks be sure 9 to perform the following settings. Set VIDEO2 for connection to the COAXIAL jack, or VIDEO3 for connection to the OPTICAL jack of the DVD player.

Note that when DVD 6ch is selected, you can only set one of either VIDEO2 or VIDEO3.

MULTI CONTROL

Preparations

SET UP

1Press the SET UP key for 2 seconds or more in the stand-by mode.

2Use the MULTI CONTROL knob to select either "6ch V2" or "6ch V3".

3Press the SET UP key to enter the contents.

•The receiver switches to the stand-by mode 3 seconds after the settings have been completed.

Connecting the DVD 6-channel jacks

DVD 6CH. INPUT	VIDEO IN		DOLBY DIGITAL / PCM IN
CENTER
L
R	VIDEO 1 VIDEO 2	VIDEO 3	VIDEO 2	VIDEO 3
SUBWOOFER SURROUND	PLAY IN	PLAY IN	CENTER
				L
				R
	VIDEO 2	VIDEO 3	SUBWOOFER SURROUND
SUB-	DVD 6CH. DVD 6CH.		PRE OUT
WOOFER
SURROUND
				COAXIAL
CENTER	FRONT	VIDEO		DIGITAL
		OUT		OUT
DVD player equipped with
six channel output jacks, etc.

•This connection diagram shows the case with DVD 6ch set to VIDEO2.

•To listen to a DVD 6-channel signal in analog 2-channel format or to use the headphones, set FRONT on the receiver to DVD player

DOWNMIX.