Speaker placement
Center speaker
Subwoofer Front
speaker
Setting up the system
Preparing the remote control
13
Loading the batteries
1 Remove the cover. | 2 Insert the batteries. |
3 Close the cover. | Preparations |
|
Surround speaker
Listening position
Front speakers : Place to the front left and right of the listening position. Front speakers are required for all surround modes. Center speaker : Place front and center. This speaker stabilizes the sound image and helps recreate sound motion. Be sure to connect a center speaker when using the Dolby 3 Stereo mode.
Surround speakers : Place to the direct left and right, or slightly behind, the listening position at even heights, approximately 1 meter above the ears of the listeners. These speakers recreate sound motion and atmosphere. Required for surround playback.
Subwoofer : Reproduces powerful deep bass sounds.
•Although the ideal surround system consists of all the speakers listed above, if you don't have a center speaker or a subwoofer, you
can divide those signals between the available speakers in the speaker settings steps to obtain the best possible surround repro-
duction from the speakers you have available. | $ |
•Insert four
Operation
When the STANDBY indicator is lit, the power turns ON when you press the POWER key on the remote control. When the power comes ON, press the key you want to operate.
Operating range |
|
(Approx.) | Remote sensor |
10 m 6 m |
|
30˚ | 30˚ |
•When pressing more than one remote control key successively, press the keys securely by leaving an interval of 1 second or more between keys.
Notes
1.The supplied batteries may have shorter lives than ordinary batteries due to use during operation checks.
2.Replace all four batteries with new ones when you notice a shortening of the distance from which the remote control will operate or if the remote control blinks 5 times when you press a key. The remote control is designed to retain set up codes in memory while you change batteries.
3.Placing the remote sensor in direct sunlight, or in direct light from a high frequency fluorescent lamp may cause a malfunction.
In such a case, change the location of the system installation to prevent malfunction.