This sets the distance from each speaker to the listening position.
œMeasure the distance from the listening position to each speaker and jot down in the table below.
Speaker | Input channel | Distance from the listening | |
status indicator | position | ||
| |||
Front speaker (left) | "L" | feet (meters) | |
Center speaker | "C" | feet (meters) | |
Front speaker (right) | "R" | feet (meters) | |
Surround speaker (right) | "RS" | feet (meters) | |
Surround Back speaker (right) | "BS" | feet (meters) | |
Surround Back speaker (left) | "BS" | feet (meters) | |
Surround Back speaker* | "BS" | feet (meters) | |
Surround speaker (left) | "LS" | feet (meters) | |
Subwoofer | "SW" | feet (meters) |
*This selection is available when "BS MONO" is selected in the speaker setup.
∑See <Getting into the setup mode> (() and select "DISTANCE".
éUse [MULTI CONTROL 5/∞] to select the distance to the front speaker.
•Adjustment will start from front left speaker.
Input channel status indicator
®Press [SETUP].
†Repeat steps é– ®to input the distance for the rest of the speaker.
¥Go to the next setting, "LFE LVL".
•If you wish to exit the setup mode, see <To exit the setup mode> (.
Low frequency effect signal is used exclusively for giving the field effect of bass tone in the Dolby Digital and DTS signal.
œSee <Getting into the setup mode> (() and select "LFE LVL".
∑Use [MULTI CONTROL 5/∞] to adjust the low frequency effect level.
• The level is adjusted from 0dB to
éPress [SETUP].
• The setup is complete when the "EXIT" indication appears.
®Press [SETUP] to exit the setup mode.
English 21