System connection

 

 

 

KTF-3010/KTF-2010 (En)

4

Connection of the Audio components/Connection of the system control cord

 

Make connections as shown below.

Malfunction of microcomputer

 

When connecting the related system components, refer also

 

to the instruction manuals of the related components.

 

 

 

Do not plug in the power lead until all connections are com-

If operation is not possible or erroneous display ap-

 

pleted.

pears even though all connections have been made

 

 

properly, rest the microcomputer referring to "In case

 

Caution regarding placement

of difficulty".

^

 

 

 

To maintain proper ventilation, be sure to leave a space around the unit (from the largest outer dimensions including projections) equal to, or greater than, shown below.

Left and right panels: 10 cm

Rear panel: 10 cm

TUNER

SYSTEM CONTROL

Pre-main amplifier

ƒ￿

L

 

KAF-3010R

SL16 XS 8

R

 

 

T R A I T

Audio cord

System control cord

OUTPUT

ANTENNA

FM 75Ω

GND

AM

L

 

 

 

 

 

 

R

AB

KTF-3010 only

SYSTEM

CONTROL

ƒ￿

SL16 XS 8

To wall AC outlet

No matter to which of the two terminals the connection is made, the use method is the same.

The system control connection

Connecting system control cords after connecting a Kenwood audio component system lets you take advantage of convenient system control operations.

There are two Kenwood system control modes. Make connections according to the groups of terminal symbols shown below.

[SL16] Mode

: for

terminals only

[XS8] Mode

: lets you combine F, f, and ƒterminals

This unit is compatible with both [SL16] and [XS8] modes. It comes from the factory set to the [SL16] mode. To switch to the [XS8] mode, follow the instructions in “Switching from [SL16] to [XS8]”.

1. [SL16] equipment cannot be combined with [XR], [XS], and [XS8] equipment for system operations. If your equipment consists of this kind of combination, please do not connect

Notes

any system control cords. Even without system control cords, normal operations can be

 

 

carried out without affecting performance.

 

2. If your amp or receiver does not have a system control terminal, do not connect any

 

system control cords to the system control terminals on the other components.

 

3. Do not connect system control cords to any components other than those specified by

 

Kenwood. It may cause a malfunction and damage your equipment.

 

4. Be sure the system control plugs are inserted all the way in to the system control termi-

 

nals.

1.Connect all cords firmly. If connections are loose, you may lose the sound or interconnectable system control operations may not work. 2.When plugging and unplugging connection cord, be sure to first remove the power cord from the AC outlet. Plugging / unplugging

Notes

connection cords without removal of the power cord can cause malfunctions or damage to the unit.